Abstract:The application of ceramic dielectrics in various microwave electronic instruments and devices is determined by their properties such as dielectric constant, dielectric loss factor, thermal conductivity, and absorptance. Alumina nitride composites with dielectric losses (high dielectric loss tangent tgδ varying from 0.1 to 0.6 ) are promising functional materials, but there are few publications with detailed dielectric characteristics including thermal conductivity, which is especially important for devices with high output power. To determine the dielectric characteristics (ε′ and tgδ), the resonance measurement method with a cylindrical resonator was employed. The electromagnetic energy absorptance L (attenuation in a bulk absorber with respect to absorber length) was used to compare absorbers of different sizes. Microwave attenuation in the absorber ring located in a resonator of the delay line of the traveling-wave tube model was measured employing a P2-61 panoramic meter for voltage standing wave ratio and attenuation. Experimental values of the real and imaginary ε′′ parts of the complex dielectric constant in pressureless-sintered AlN–SiC composites with different contents and sizes of semiconducting silicon carbide particles are presented. When SiC increases from 20 to 50% in the AlN-based composite, ε′ becomes 1.7–2.1 times higher and ε′′ 5.4–6.8 times higher. The smaller the SiC particles, the greater the increase in ε′ and ε′′, silicon carbide content being the same. The relationship between the thermal conductivity and electromagnetic energy absorptance in the AlN–SiC composites was studied. The range of compromise values was found: they combine relatively high thermal conductivity, 45–55 W/(m · K), and significant absorptance, L = 2.8–3.5 dB/mm, corresponding to the highest silicon carbide content (40–50%) and microsized SiC particles (2.3–4.4 μm). A relationship was established between the imaginarabsorptance L(dB/mm) , allowing the absorptance to be determined from known ε′′ at a frequency of 3.3 GHz.

Helium Permeability Measurement of Sic Ceramic Composites for Advanced Reactor Application

Investigation of Electrical and Thermal Properties of Epoxy Resin/Silicon Carbide Whisker Composites for Electronic Packaging Materials

In-situ X-ray tomography on permeability evolution of C/SiC porous ceramic for hypersonic vehicles

Relation Between Porosity and Permeability of Ceramic Membrane Supports

Contact Angle Measurement of Molten Lead-Lithium on Silicon Carbide Surfaces

Pressureless Infiltration Preparation of High SiC/Al Ceramic Matrix Composites

Porous SiC ceramic obtained by spark plasma sintering of preceramic paper: Microstructure, mechanical properties and gas permeability

A novel porous carbon synthesized to serve in the preparation of highly dense and high-strength SiC/SiC by reactive melt infiltration

Preparation and Properties of C/SiC Composites Reinforced by High Thermal Conductivity Graphite Films

Influence of mass ratios between SiC particles and chopped carbon fibers on properties of C/SiC/SiO2 porous ceramics

Permeating behaviour of porous SiC ceramics fabricated with different SiC particle sizes

The Effect of Molten Salt Infiltration on 2D SiCf/SiC Composite by Chemical Vapour Infiltration

Preparation, mechanical, dielectric and microwave absorption properties of hierarchical porous SiCnw-Si3N4 composite ceramics

Permeability Behavior and Wastewater Filtration Performance of Mullite Bonded Porous SiC Ceramic Membrane Prepared Using Coal Fly Ash as Sintering Additive

Influence of the Silicon Carbide Particle Size on Dielectric Characteristics, Thermal Conductivity, and Microwave Absorption of Pressureless-Sintered AlN–(20–50)% SiC Composites

Numerical simulation of heat transfer during spark plasma sintering of porous SiC

Fabrication and investigations on Si3N4/PAN/SiZrOCN ceramic aerogel composites with high-temperature wave permeability

Experimental and Numerical Analysis of the Thermal Conductivity of SiCf/SiC Composites

Gas Permeation Property of Silicon Carbide Membranes Synthesized by Counter-Diffusion Chemical Vapor Deposition

Processing and microstructure-permeation properties of silica bonded silicon carbide ceramic membrane

Study on transpiration cooling performance of SiC porous ceramics