Abstract:This paper reports a novel capacitive accelerometer with highly symmetrical double-sided beam-mass structure. The highly symmetrical structure is fabricated from single wafer by a novel vertical sidewall protection technique. The good device performance is obtained by highly symmetrical double-sided beam-mass structure and fabrication process that enable formation of a large proof mass, controllable thickness of beam, and a narrow uniform capacitive gap over a large area. The resonance frequency of the accelerometer is measured in open loop system by a network analyzer. The quality factor and the resonant frequency are 34 and 787Hz, respectively. The accelerometer with closed loop interface circuit is calibrated on B&K Vibration Transducer Calibration System (Type 3629). The typical measurement range of the device is 1g, and the maximum range is 2g. The capacitance sensitivity of the fabricated accelerometer is 11.7pF/g. The sensitivity of the device with closed loop interface circuit is 1V/g, and the nonlinearity is 0.39% over the range of 1g. The cross-sensitivity x/z is 0.72% and y/z is 0.50%, respectively. The accelerometer with closed loop circuit has wide bandwidth of DC to 1kHz (3dB). Also the bias stability is 255μg. The device with closed loop circuit has signal to noise ratio (SNR) of 106dB, the average noise floor is 3.1μg/Hz (0–100Hz).

Micromachined Tri-Axis Capacitive Accelerometer Based on the Single Mass

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Study of a Novel Micromachined Capacitive Accelerometer

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

A Biaxial Capacitive Microaccelerometer with A Single Proof-Mass

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Fabrication and Test of a Capacitive Biaxial Microaccelerometer

Design of dual-axis micromachined accelerometer

A 3-axis MEMS capacitive accelerometer free of cross axis sensitivity

A Novel Sandwich Capacitive Accelerometer with A Double-Sided 16-Beam-mass Structure

A Novel Triaxial Micro Accelerometer

Structure Design of A Novel Triaxial Micro-Accelerometer

Z-Axis Capacitive Accelerometer With Novel Beams Using Sog Structure

A new structure and modeling of a three-axis MEMS capacitive accelerometer with high dynamic range and sensitivity

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

New capacitive low-g triaxial accelerometer with low cross-axis sensitivity

Design and Simulation of A Capacitive Biaxial Microaccelerometer

Design and simulation of a novel MEMS-based single proof mass three-axis piezo-capacitive accelerometer

A Novel Capacitive Accelerometer with A Highly Symmetrical Double-Sided Beam-Mass Structure

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass