Modeling Grease Mechanical Degradation with Entropy at Moderate Shear Rates

Alan Gurt,Michael Khonsari

DOI: https://doi.org/10.1016/j.triboint.2024.110424

IF: 5.62

2024-12-03

Tribology International

Abstract:Mechanical degradation can substantially affect the rheological properties of a grease sample, consequently leading to bearing failure. Despite this importance, the exact physics of mechanical degradation and appropriate measurement techniques are not well understood. This paper shows that the quantification of mechanical degradation is quite complex, where the orientation of thickener geometry immediately after shearing is shown to substantially affect measurements. Thus, a suitable sample preparation and stabilization process is needed to isolate the irreversible effects of mechanical degradation from the reversible effects of thickener alignment. This paper follows the development of appropriate, practical techniques for measuring grease degradation using small samples, allowing a small sample to be taken from an end application and measured to track its degradation. Using these techniques, a systematic procedure for appropriately measuring and modeling mechanical degradation is provided.In this paper, mechanical degradation at moderate shear rates is examined in detail by shearing grease in a rheometer for extended intervals, and results are interpreted in the context of Degradation-Entropy Generation theory. It is found that a substantial amount of permanent degradation may be induced at very low shear rates, where it was previously assumed to be negligible. This places a restriction on models used to only include moderate shear rates. Because most bearings operate in the moderate shear rate region and most mechanical degradation happens in the initial stage of bearing operation, this approach represents a practical method for estimating the change in rheological properties that affect bearing life.

engineering, mechanical