Abstract:This paper focuses on the study of thickener behaviour in elastohydrodynamic contacts using fluorescence microscopy and optical interferometry. A standard Ball-on-disc configuration tribometer was used as well as a newly developed Ball-on-ring configuration tribometer mimicking the conditions in a 6314 deep groove ball bearing. Three types of custom-made greases were used with the same base oil and Coumarin 6 fluorescent dye on the thickener. These greases contained no additives and were of the lithium complex and alicyclic di-urea type. It was confirmed that the behaviour of the grease was directly influenced by both the structure and type of thickener, and the differences were successfully observed by fluorescence microscopy. The concentration of thickener was found to change due to the formation or breakdown of the deposited thickener layer on the track. At low speeds, the alicyclic di-urea forms a thickener layer on the track that is more pronounced than the lubricating film formed by the base oil alone. The thickener layer formation also occurs at higher speeds when fully flooded conditions are beneficial in building the layer. Experiments with a Ball-on-ring tribometer show that the natural replenishment of the real contact geometry is more effective than on a Ball-on-disc tribometer, but the formation of the thickener layer on the track is more limited than in a Ball-on-disc tribometer with artificial replenishment. At higher velocities, a smaller but stable layer is formed where the layer does not change much from a certain velocity.

Film Thickness Decay and Replenishment in Point Contact Lubricated with Different Greases: A Study into Oil Bleeding and the Evolution of Lubricant Reservoir

Effects of Nano Thickener Deposited Film on the Behaviour of Starvation and Replenishment of Lubricating Greases

Starvation and Reflow of Point Contact Lubricated with Greases of Different Chemical Formulation

Effects of Slide/Roll Ratio on the Behaviours of Grease Reservoir and Film Thickness of Point Contact

Mechanism of Nano-Scale Thickener Deposited Film in Starved Grease Lubrication

Experimental Investigation of Lubrication Film Starvation of Polyalphaolefin Oil at High Speeds

Film-Forming Characteristics of Grease in Point Contact under Swaying Motions

Vibrations and film thickness in grease-lubricated deep groove ball bearings

Prediction of bleeding behavior and film thickness evolution in grease lubricated rolling contacts

Fully Flooded, Starved and Parched Lubrication at a Point Contact System

Experimental Investigation of Centrifugal Effects on Lubricant Replenishment in the Starved Regime at High Speeds

Grease Lubrication: Formulation Effects on Tribological Performance

Direct Observation of the Impact of Water Droplets on Oil Replenishment in EHD Lubricated Contacts

Effect of Chevron-shaped wetting patterns on oil film thickness in cylinder-on-disc contact under starved lubrication or limited lubricant supply

Thickener Behaviour in Rolling Elastohydrodynamic Lubrication Contacts

Development of Wear and Pitting Curves with Vibration Analysis for Lubricating Grease under Contamination Conditions

Effect of liquid contaminants on tribological performance of greases

Experimental Investigation of Lubrication Properties at High Contact Pressure

The Film Behaviors of Grease in Point Contact During Microoscillation

Online monitoring of oil film thickness of journal bearing in aviation fuel gear pump

An Experimental-Study on Oil-Supply in A Space Bearing with an Oil-Impregnated Retainer