Abstract:This study investigates friction and film thickness in elastohydrodynamic contacts of machined, rough surfaces, where roughness is dominated by longitudinal ridges parallel to the rolling/sliding direction. A ball-on-disc tribometer was used to simultaneously measure friction and film thickness in rough contacts as well as with nominally smooth specimens for comparison. The studied rough surfaces were selected so that the influence of the root-mean-square roughness and roughness wavelength can be assessed. Friction and film measurements were taken over a range of slide–roll ratios and speeds and with two lubricating oils with different viscosities, hence covering a wide range of specific film thicknesses. The measurements with the nominally smooth specimens show that friction is strongly influenced by thermal effects at high SRRs and that the transition from mixed/boundary to full EHD lubrication occurs at lambda ratios greater than three. At low speeds, the rough specimens are found to generate higher friction than the smooth ones for all the roughness structures considered, and this is shown to be related to the thinner minimum film thickness. Comparison of friction in rough and smooth contacts shows that the total friction in rough contacts can be divided into two components: one that is equivalent to friction in smooth contacts under the same conditions and is dependent on the slide–roll ratio, and the other that is due to the presence of roughness and is independent of the slide–roll ratio under the conditions tested. Further analysis of the minimum film thickness on tops of roughness ridges indicates that even after the full lift-off, an effect of the roughness on friction persists and is most likely related to the local shear stress in the micro-EHD contacts on the top of roughness ridges. At even higher speeds, the difference in friction between the rough and smooth specimens vanishes.

Film-Forming Characteristics of Grease in Point Contact under Swaying Motions

The Film Behaviors of Grease in Point Contact During Microoscillation

Effects of Slide/Roll Ratio on the Behaviours of Grease Reservoir and Film Thickness of Point Contact

Film Thickness Decay and Replenishment in Point Contact Lubricated with Different Greases: A Study into Oil Bleeding and the Evolution of Lubricant Reservoir

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Experimental Investigation of Lubrication Properties at High Contact Pressure

Prediction of bleeding behavior and film thickness evolution in grease lubricated rolling contacts

Elastohydrodynamic Lubrication Analysis on Line Contact Lubricated with Grease

Experimental Investigation of Lubrication Film Starvation of Polyalphaolefin Oil at High Speeds

Starvation and Reflow of Point Contact Lubricated with Greases of Different Chemical Formulation

Mechanism of Nano-Scale Thickener Deposited Film in Starved Grease Lubrication

Numerical simulations of lubricated contact - Effects of variation of entraining velocity

Grease Lubrication: Formulation Effects on Tribological Performance

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

Film forming behavior in thin film lubrication at high speeds

The film forming behavior at high speeds under oil−air lubrication

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

Effects of Nano Thickener Deposited Film on the Behaviour of Starvation and Replenishment of Lubricating Greases

The investigation of contact ratio in mixed lubrication

The Relationship Between Friction and Film Thickness in EHD Point Contacts in the Presence of Longitudinal Roughness

Oil Film Velocity Analysis in the Thermal Elastic Hydrodynamic Lubrication of Heavy Loading Point Contact