Abstract:This study investigates friction and film thickness in elastohydrodynamic contacts of machined, rough surfaces, where roughness is dominated by longitudinal ridges parallel to the rolling/sliding direction. A ball-on-disc tribometer was used to simultaneously measure friction and film thickness in rough contacts as well as with nominally smooth specimens for comparison. The studied rough surfaces were selected so that the influence of the root-mean-square roughness and roughness wavelength can be assessed. Friction and film measurements were taken over a range of slide–roll ratios and speeds and with two lubricating oils with different viscosities, hence covering a wide range of specific film thicknesses. The measurements with the nominally smooth specimens show that friction is strongly influenced by thermal effects at high SRRs and that the transition from mixed/boundary to full EHD lubrication occurs at lambda ratios greater than three. At low speeds, the rough specimens are found to generate higher friction than the smooth ones for all the roughness structures considered, and this is shown to be related to the thinner minimum film thickness. Comparison of friction in rough and smooth contacts shows that the total friction in rough contacts can be divided into two components: one that is equivalent to friction in smooth contacts under the same conditions and is dependent on the slide–roll ratio, and the other that is due to the presence of roughness and is independent of the slide–roll ratio under the conditions tested. Further analysis of the minimum film thickness on tops of roughness ridges indicates that even after the full lift-off, an effect of the roughness on friction persists and is most likely related to the local shear stress in the micro-EHD contacts on the top of roughness ridges. At even higher speeds, the difference in friction between the rough and smooth specimens vanishes.

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

EHL Properties of Roller Contacts and Its Application Part Ⅱ: A Numerical Analysis of EHL for Engineering Logarithmic Roller

A Full Numerical Solution for the Thermoelastohydrodynamic Problem in Elliptical Contacts

Prediction of oil-film thickness and shape in elliptical point contacts under combined rolling and sliding motion

About the Load-Carrying Capacity of Elastohydrodynamic Lubrication Film

An Analysis of Elastohydrodynamic Lubrication with Limiting Shear Stress: Part I—Theory and Solutions

On Thermal Reduction Factor for Elastohydrodynamic Film Thickness in Rolling/Sliding Contacts

A Lubrication Deviation From the Classical EHL Theory by the Lubricant Viscoplasticity: Part I - Film Thickness Dependence

EHL Film Thickness Limitation Theory Under a Limiting Shear Stress

A fast calculation approach for elastohydrodynamic finite line contacts applicable to online calculations of rolling bearing models

Effects of boundary slips on thermal elastohydrodynamic lubrication under pure rolling and opposite sliding contacts

Prediction of film thickness in starved EHL point contacts using two-phase flow CFD model

The Relationship Between Friction and Film Thickness in EHD Point Contacts in the Presence of Longitudinal Roughness

Influence of Thermal Effects on Elastohydrodynamic (EHD) Lubrication Behavior at High Speeds

Effect of roughness on lubrication of low elastic modulus in line contact

Elastohydrodynamic Lubrication Analysis of Tapered Roller Bearing Considering effect of free Ends

Elastohydrodynamic Lubrication Analysis on Line Contact Lubricated with Grease

Effects of Rough Surface Topography and Orientation on the Characteristics of EHD and Mixed Lubrication in Both Circular and Elliptical Contacts

Aspects of modeling and numerical simulation of dry point contacts between viscoelastic solids

Micro-elastohydrodynamic lubricant film formation in rotary lip seal contacts

EHL Performance of the Lubricant with Shear Strength: Part I — Boundary Slippage and Film Failure