Abstract:This study investigates friction and film thickness in elastohydrodynamic contacts of machined, rough surfaces, where roughness is dominated by longitudinal ridges parallel to the rolling/sliding direction. A ball-on-disc tribometer was used to simultaneously measure friction and film thickness in rough contacts as well as with nominally smooth specimens for comparison. The studied rough surfaces were selected so that the influence of the root-mean-square roughness and roughness wavelength can be assessed. Friction and film measurements were taken over a range of slide–roll ratios and speeds and with two lubricating oils with different viscosities, hence covering a wide range of specific film thicknesses. The measurements with the nominally smooth specimens show that friction is strongly influenced by thermal effects at high SRRs and that the transition from mixed/boundary to full EHD lubrication occurs at lambda ratios greater than three. At low speeds, the rough specimens are found to generate higher friction than the smooth ones for all the roughness structures considered, and this is shown to be related to the thinner minimum film thickness. Comparison of friction in rough and smooth contacts shows that the total friction in rough contacts can be divided into two components: one that is equivalent to friction in smooth contacts under the same conditions and is dependent on the slide–roll ratio, and the other that is due to the presence of roughness and is independent of the slide–roll ratio under the conditions tested. Further analysis of the minimum film thickness on tops of roughness ridges indicates that even after the full lift-off, an effect of the roughness on friction persists and is most likely related to the local shear stress in the micro-EHD contacts on the top of roughness ridges. At even higher speeds, the difference in friction between the rough and smooth specimens vanishes.

Effect of roughness on lubrication of low elastic modulus in line contact

Micro-Elastohydrodynamics Lubrication of Point Contacts with Coexistence of Longitudinal and Transverse Roughness

Effects of Rough Surface Topography and Orientation on the Characteristics of EHD and Mixed Lubrication in Both Circular and Elliptical Contacts

The Relationship Between Friction and Film Thickness in EHD Point Contacts in the Presence of Longitudinal Roughness

Understanding the Influences of Multiscale Waviness on the Elastohydrodynamic Lubrication Performance, Part II: the Partial-Film Condition

Transition of frictional states and surface roughness effects in lubricated contacts

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

Modelling for Water-Based Liquid Lubrication with Ultra-Low Friction Coefficient in Rough Surface Point Contact

Influence of anisotropic surface roughness on lubricated rubber friction with application to hydraulic seals

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

STUDY ON ELASTOHYDRODYNAMIC LUBRICATION PROBLEMS WITH REAL ROUGH SURFACES IN LINE AND POINT CONTACTS

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Contact Ratio of Rough Surfaces with Multiple Asperities in Mixed Lubrication at High Pressures

Elastohydrodynamic Lubrication of Soft, Highly Deformed Contacts

Effect of elastic deformation on squeezing film lubrication properties of soft tribocontacts with microstructured surface

A Mixed Elastohydrodynamic Lubrication Model With Asperity Contact

Study on effect of surface roughness wavelength in viscoelastic fluid lubrication using correspondence theory

Influence of wall slip of lubricants on performance of elastohydrodynamic lubrication in line contact

Numerical Analysis on the Effect of Transverse Surface Roughness in Non-Newtonian Fluid Lubrication

Soft lubrication: the elastohydrodynamics of non-conforming and conforming contacts

About the Load-Carrying Capacity of Elastohydrodynamic Lubrication Film