Abstract:Microoscillation is a typical case of transient motion, which occurs in many machine elements, including rolling or sliding element bearings, cams, and gears. Wear is easy to occur on the surface of such elements, particularly at the end point of the stroke, where the surfaces are momentarily static. In the present work, an experimental investigation is conducted to explore the grease film behavior of point contact lubrication during microoscillation in the case of pure rolling or pure sliding. The technique of relative optical interference intensity was used to monitor the variation of the grease film thickness and the motion of the grease in the contact area through analyzing the captured interferograms. Experimental results indicate that a crescent-shaped grease film can form along the motion direction in the contact area under microoscillation. The grease film is formed in the inlet region, and the film thickness remains while moving in the Hertzian contact area. In the case of pure rolling, the crescent-shaped grease film and the initial entrapped grease film are carried by a tow effect of moving interfaces in the contact area. However, in the case of pure sliding, there are relative motions in the sliding direction at the two interfaces of the grease/ball and the grease/disk in the Hertzian contact area. The shape of the entrapped grease remains almost unchanged while moving in the Hertzian contact area. During the repetition of microoscillations, the crescent-shaped grease film thickness drops gradually.

Effects of Slide/Roll Ratio on the Behaviours of Grease Reservoir and Film Thickness of Point Contact

Starvation and Reflow of Point Contact Lubricated with Greases of Different Chemical Formulation

Film Thickness Decay and Replenishment in Point Contact Lubricated with Different Greases: A Study into Oil Bleeding and the Evolution of Lubricant Reservoir

Film-Forming Characteristics of Grease in Point Contact under Swaying Motions

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Effects of Nano Thickener Deposited Film on the Behaviour of Starvation and Replenishment of Lubricating Greases

The Film Behaviors of Grease in Point Contact During Microoscillation

Mechanism of Nano-Scale Thickener Deposited Film in Starved Grease Lubrication

Experimental Investigation of Lubrication Film Starvation of Polyalphaolefin Oil at High Speeds

Film Thickness Changes in EHD Sliding Contacts Lubricated by a Fatty Alcohol

Grease Lubrication: Formulation Effects on Tribological Performance

Elastohydrodynamic Lubrication Analysis on Line Contact Lubricated with Grease

Prediction of bleeding behavior and film thickness evolution in grease lubricated rolling contacts

Effect of liquid contaminants on tribological performance of greases

Effects of oil film properties on roller bearing with light loads under various slip factors

Study of the changes in the microstructures and properties of grease using ball milling to simulate a bearing shear zone on grease

Experimental Investigation of Lubrication Properties at High Contact Pressure

Vibrations and film thickness in grease-lubricated deep groove ball bearings

Effects of Pfpe Lubricant Properties on the Critical Clearance and Rate of the Lubricant Transfer from Disk Surface to Slider

Experimental Study of the Effect of Thickener on the Film Thickness in the Contacts of a Grease-Lubricated Ball Bearing at Low Speed

Rheological and Tribological Properties of Lithium Grease and Polyurea Grease with Different Consistencies