Abstract:To reveal the film formation mechanism of oil-in-water (O/W) emulsions, the thicknesses of nanofilms of an aqueous paraffin oil emulsion, stabilized with the nonionic Tween 80 and Span 80 surfactants, were measured in confinement between two solid surfaces, by the use of the relative optical interference intensity (ROII) approach. Such films' thicknesses were found to be sensitive to the rolling speed. In contrast to a single-phase oil lubricant, which as an elastohydrodynamic film had a thickness that always increased with speed when there was a sufficient supply of new material, the film formation of oil-in-water emulsions normally has a hill-like appearance (the film undergoes a collapse to a relatively low thickness at a critical speed after the evident rise in thickness with increasing rolling speed). The critical speeds for film formation of O/W emulsions with various emulsifiers and oil concentrations were focused on to gain an insight into the film formation mechanism of oil-in-water emulsions. Droplets can be observed to concentrate and break up before the contact at a low speed, which induces an oily pool. The oily pool seemed to act as the provider of the lubrication of the contact during the rolling process. The re-emulsification effect was employed to explain the collapse of the film thickness as the speed exceeded the critical value. A theoretical model was proposed to describe the re-emulsification effect, which established a relationship between the critical speed and the concentrations of either the oil or the emulsifiers.

The film forming behavior at high speeds under oil−air lubrication

Film forming behavior in thin film lubrication at high speeds

Investigation of Film Formation Mechanism of Oil-In-Water (O/W) Emulsions at High Speeds

Experimental Investigation of Lubrication Film Starvation of Polyalphaolefin Oil at High Speeds

Experimental Analysis On Oil Film Properties Of Plane Port Pair In Axial Piston Machine

Lubricating Properties of Aviation Oil 4010 under High-pressure Micro Clearance

Research on Oil Film Forming of Port Pair in Axial Piston Pump and its Prediction

Experimental Investigation of Lubrication Properties at High Contact Pressure

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

Effect of Microcontent of Oil in Water under Confined Condition

The Film Formation Mechanism Of High Water-Based Emulsions

Spreading Behavior of Single Oil Droplet Impacting Surface with/without a Thin Liquid Film

Film Forming Characteristics of Oil-in-water Emulsion with Super-Low Oil Concentration

Numerical Investigation for Characteristics and Oil–air Distributions of Oil Film in a Tilting-Pad Journal Bearing

Experimental Investigation of Centrifugal Effects on Lubricant Replenishment in the Starved Regime at High Speeds

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Film-Forming Characteristics of Grease in Point Contact under Swaying Motions

Influence of Thermal Effects on Elastohydrodynamic (EHD) Lubrication Behavior at High Speeds

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Film Thickness Properties of Confined Gear Oil at High Contact Pressures

Effects of oil-air lubrication methods on the internal fluid flow and heat dissipation of high-speed ball bearings