Abstract:To reveal the film formation mechanism of oil-in-water (O/W) emulsions, the thicknesses of nanofilms of an aqueous paraffin oil emulsion, stabilized with the nonionic Tween 80 and Span 80 surfactants, were measured in confinement between two solid surfaces, by the use of the relative optical interference intensity (ROII) approach. Such films' thicknesses were found to be sensitive to the rolling speed. In contrast to a single-phase oil lubricant, which as an elastohydrodynamic film had a thickness that always increased with speed when there was a sufficient supply of new material, the film formation of oil-in-water emulsions normally has a hill-like appearance (the film undergoes a collapse to a relatively low thickness at a critical speed after the evident rise in thickness with increasing rolling speed). The critical speeds for film formation of O/W emulsions with various emulsifiers and oil concentrations were focused on to gain an insight into the film formation mechanism of oil-in-water emulsions. Droplets can be observed to concentrate and break up before the contact at a low speed, which induces an oily pool. The oily pool seemed to act as the provider of the lubrication of the contact during the rolling process. The re-emulsification effect was employed to explain the collapse of the film thickness as the speed exceeded the critical value. A theoretical model was proposed to describe the re-emulsification effect, which established a relationship between the critical speed and the concentrations of either the oil or the emulsifiers.

Investigation of Film Formation Mechanism of Oil-In-Water (O/W) Emulsions at High Speeds

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

Increased Film Thickness of Oil-in-Water (O/W) Emulsions at High Speed

The Film Formation Mechanism Of High Water-Based Emulsions

Film Forming Characteristics of Oil-in-water Emulsion with Super-Low Oil Concentration

The film forming behavior at high speeds under oil−air lubrication

Dramatically Enhanced Film-Formation Performance Using O/W Emulsion under Starving Feeding Mode

Effect of Droplet Size on the Film Formation of O/W Emulsion

Behavior of O/W Emulsion under Point Contact

Experimental Investigation of Lubrication Film Starvation of Polyalphaolefin Oil at High Speeds

Hydrodynamic Cavitation As an Efficient Method for the Formation of Sub-100 Nm O/W Emulsions with High Stability

Reemulsification Effect on the Film Formation of O/W Emulsion.

Direct observation of the formation and destruction of the inverted continuous oil phase in the micro-outlet region achieved by the confined diluted O/W emulsion stream.

Experimental Investigation of Lubrication Properties at High Contact Pressure

Electric-Fields-Enhanced Destabilization of Oil-In-Water Emulsions Flowing Through A Confined Wedgelike Gap

Film forming behavior in thin film lubrication at high speeds

Investigation of the liquid crystal additive's influence on film formation in nano scale

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Study on microstructure evolution of waxy crude oil emulsions under dynamic cooling conditions

Effect of Microcontent of Oil in Water under Confined Condition

Fluorescence in Situ Observation of the Interfacial Dynamics and Adhesion Behaviors of Water and Oil Droplets in A Confined Geometry