Abstract:Oil-in-water emulsions provide an essential contribution to enhanced oil recovery by acting as oil displacement and conformance control systems. However, the dominant factors affecting their emulsification and kinetics are unclear. The emulsification rate is usually defined in terms of changes in the torque, conductivity, or particle size over time, which results in inaccurately calculated emulsified oil amounts. Therefore, the effects of temperature, pH, and NaCl concentration on the emulsified mass and droplet sizes of aqueous emulsions of Jin8-7 and Chen373 oil with octadecyl amine ethoxylate ether as an emulsifier were investigated. The results showed that the formation of oil-in-water emulsions of Jin8-7 and Chen373 under different conditions occurred via a two-stage mechanism: rapid emulsification and emulsion maturation. The emulsified oil mass rapidly increased during the rapid emulsification period and plateaued during the emulsion maturation period. This indicates that the emulsified oil mass largely depended on the short rapid emulsification period. It was also found that increasing the temperature and pH were more conducive to the emulsification of Chen373 oil with a high viscosity and high asphaltene content. The optimal NaCl concentration was determined to be 2% and 4% for Chen373 and Jin8-7 oil, respectively, based on the emulsification mass during the rapid emulsification period. The droplet size decreased first and then increased during the emulsification process under most experimental conditions. A second-order kinetics model for emulsification was proposed, in which the evolution of emulsified oil mass calculated with time agreed with the experimentally measured values. This study can provide theoretical guidance for the implementation of chemical cold production of heavy oil in oilfields.

Film Forming Characteristics of Oil-in-water Emulsion with Super-Low Oil Concentration

The Film Formation Mechanism Of High Water-Based Emulsions

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

Investigation of Film Formation Mechanism of Oil-In-Water (O/W) Emulsions at High Speeds

Effect of Droplet Size on the Film Formation of O/W Emulsion

Dramatically Enhanced Film-Formation Performance Using O/W Emulsion under Starving Feeding Mode

Increased Film Thickness of Oil-in-Water (O/W) Emulsions at High Speed

Effect of Microcontent of Oil in Water under Confined Condition

Effect of Solid Surface on the Formation of Thin Confined Lubricating Film of Water with Micro-Content of Oil

Behavior of O/W Emulsion under Point Contact

Effect of Free Water on Film Forming Characteristics of Lubricating Oil in Point Contact Zone

The effect of emulsifier concentration on the lubricating properties of oil-in-water emulsions

Reemulsification Effect on the Film Formation of O/W Emulsion.

Monitoring the transition of lubrication status of O/W emulsion with electric resistance technique

The film forming behavior at high speeds under oil−air lubrication

Progress in Experimental Study of Aqueous Lubrication

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Experimental Investigation of Lubrication Properties at High Contact Pressure

Microscopic Aggregation and Film‐Forming Characteristics of Lubricant Additives on Oil–Water Interface: MD Simulation and Experiments on Water Separability

Factors and Kinetics Related to the Formation of Heavy Oil-in-Water Emulsions

The Formation, Stabilization and Separation of Oil–Water Emulsions: A Review