Abstract:To reveal the film formation mechanism of oil-in-water (O/W) emulsions, the thicknesses of nanofilms of an aqueous paraffin oil emulsion, stabilized with the nonionic Tween 80 and Span 80 surfactants, were measured in confinement between two solid surfaces, by the use of the relative optical interference intensity (ROII) approach. Such films' thicknesses were found to be sensitive to the rolling speed. In contrast to a single-phase oil lubricant, which as an elastohydrodynamic film had a thickness that always increased with speed when there was a sufficient supply of new material, the film formation of oil-in-water emulsions normally has a hill-like appearance (the film undergoes a collapse to a relatively low thickness at a critical speed after the evident rise in thickness with increasing rolling speed). The critical speeds for film formation of O/W emulsions with various emulsifiers and oil concentrations were focused on to gain an insight into the film formation mechanism of oil-in-water emulsions. Droplets can be observed to concentrate and break up before the contact at a low speed, which induces an oily pool. The oily pool seemed to act as the provider of the lubrication of the contact during the rolling process. The re-emulsification effect was employed to explain the collapse of the film thickness as the speed exceeded the critical value. A theoretical model was proposed to describe the re-emulsification effect, which established a relationship between the critical speed and the concentrations of either the oil or the emulsifiers.

Monitoring the transition of lubrication status of O/W emulsion with electric resistance technique

Film Forming Characteristics of Oil-in-water Emulsion with Super-Low Oil Concentration

Dramatically Enhanced Film-Formation Performance Using O/W Emulsion under Starving Feeding Mode

A New Measurement Method Of Oil Film Thickness In The Ehl Condition - The R-C Oscillation Technique

Relationship between Viscosity and Resistance of Oil Film: A New Way to Investigate the Controllable Friction between Charged Interfaces Lubricated by Ionic Lubricating Oil

The Film Formation Mechanism Of High Water-Based Emulsions

Behavior of O/W Emulsion under Point Contact

Investigation of Film Formation Mechanism of Oil-In-Water (O/W) Emulsions at High Speeds

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Exploring electrical metrics for tribology measures in oil films: System design, analysis principle and physical effects

Investigation on On-Line Monitoring Method for Lubricating Oil Deterioration

Experimental investigation of lubricant flow properties under micro oil supply condition

Application of On-line Monitoring Technology on Heavy Power Reducer Lubrication Oil

PREPARATION AND TRIBOLOGICAL PERFORMANCE OF MICRO-EMULSIFIED BIO-OIL

Experimental Investigation of Lubrication Properties at High Contact Pressure

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

The effect of emulsifier concentration on the lubricating properties of oil-in-water emulsions

Research on tribological condition on-line monitoring system

Fluorescence in Situ Observation of the Interfacial Dynamics and Adhesion Behaviors of Water and Oil Droplets in A Confined Geometry

Monitoring Lubrication and Wear in-situ by triboelectrification Under Vacuum Conditions

Effect of Droplet Size on the Film Formation of O/W Emulsion