Abstract:It has been long understood that fretting differs from sliding wear in that the relative displacement between the bodies is generally smaller than the size of the contact between them, with debris ejection from the contact thus playing an important role in the behaviour of the contact in fretting. Whilst these ideas were clearly articulated more than 30 years ago via Godet's third-body approach and Berthier's concept of the tribology circuit, calculation of wear rates in fretting have continued to employ Archard's wear equation (or approaches directly derived from it), despite this approach assuming that the rate of wear is controlled by the rate of generation of wear debris (as opposed to the rate of its ejection from the contact). It has been shown recently that when debris ejection is the rate-determining-process in fretting, the instantaneous rate of wear is inversely proportional to a characteristic dimension of the wear scar. When non-conforming specimen pair geometries (such as cylinder-on-flat) are employed in fretting testing, the wear scar size increases as wear proceeds, and thus the instantaneous rate of wear decreases. In this paper, wear equations have been derived for three commonly employed non-conforming pair specimen geometries, which all take the form <math>Vw=KRn−1Edn</math> (<math>Vw</math> is the wear scar volume, <math>R</math> is the radius of the non-plane specimen(s) in the pair and <math>Ed</math> is the frictional energy dissipated) where <math>n</math> varies between 0.67 and 0.8 depending upon the geometry and assumptions made regarding the governing equation. It is argued that the assumptions on which the analysis is based are most valid for the cylinder-on-flat contact configuration with fretting perpendicular to the cylinder axis where the length of the line contact is large compared to the wear scar width. It is demonstrated that, despite the often apparently good fit of experimental data to an Archard-type equation, it is not appropriate to employ such Archard-type approaches to the analysis of fretting data in situations where debris ejection is the rate-determining-process. The equations derived in this paper relating wear scar size to some measure of the duration of the test should be used for such analysis instead of the linear relationships generally employed in previous work.

Characterization of abrasive wear using degradation coefficient

Experimental Investigation of Correlation Between Attrition Wear and Features of Acoustic Emission Signals in Single-Grit Grinding

Gear Wear Prediction Based on the Theorem of Degradation Entropy Generation

Accelerated Wear Test Design Based on Dissipation Wear Model Entropy Analysis under Mixed Lubrication

Wear Behavior of Iron Based Alloys with Different Entropy Extent Estimated by Miedema's Model

Mechanisms of abrasive wear in lubricated contacts

Waviness Affects Friction and Abrasive Wear

Abrasive wear behaviour of polymeric materials

Contact size and debris ejection in fretting: The inappropriate use of Archard-type analysis of wear data and the development of alternative wear equations for commonly employed non-conforming specimen pair geometries

Engineering Relationships for Computational and Analytical Prediction of Coating Wear during Tribological Tests

Debris effect on the surface wear and damage evolution of counterpart materials subjected to contact sliding

Analysis of friction coefficient evolutions on coated systems under sliding conditions

FEM computation of groove ridge and Monte Carlo simulation in two-body abrasive wear

Modeling Grease Mechanical Degradation with Entropy at Moderate Shear Rates

On the Use of Alternative Measurement Methods in the Estimation of Wear Rates in Rotary-Pin-on-Disk Tribometry

Contact Analysis of Abrasive Wear

Friction and wear performance of polyether ether ketone (PEEK) polymers in three lubrication regimes

Prediction of wear volume and friction coefficients of SS304 alloy using grey taguchi based response surface methodology

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Reliability Analysis for the Dependent Competing Failure With Wear Model and its Application to the Turbine and Worm System

Quantitative Prediction of Wear Failure Based on Dissipative Methodology under Dry Friction