Abstract:The development of efficient sample introduction and pretreatment systems for microfluidic chip-based analytical systems is important for their application to real-life samples. In this work, world-to-chip interfacing was achieved by a novel flow-through sampling reservoir featuring a guided overflow design. The flow-through reservoir was fabricated on a 30 x 60 x 3 mm planar glass chip of crossed-channel design used for capillary electrophoresis separations. The 20-microL sample reservoir was produced from a section of plastic pipet tip and fixed at one end of the sampling channel. Sample change was performed by pumping 80-microL samples sandwiched between air segments at approximately 0.48 mL/min flow rate through the flow-through reservoir, introduced from an access hole on the bottom side of the chip. A filter paper collar wrapped tightly around the reservoir guided the overflowing sample solution into a plastic trough surrounding the reservoir and then to waste. The performance of the system was demonstrated in the separation and determination of FITC-labeled arginine, glycine, phenylalanine, and glutamic acid with LIF detection, by continuously introducing a train of different samples through the system without electrical interruption. Employing a separation channel of 4 cm (2-cm effective separation length) and 1.4-kV separation voltage, maximum throughputs of 80/h were achieved with <4.1% carryover and precisions ranging from 1.5% for arginine to 2.6% RSD (n = 11) for glycine. The sampling system was tested in the continuous monitoring of the derivatizing process of amino acids by FITC over a period of 4 h, involving 166 analytical cycles. An outstanding overall precision of 4.8% RSD (n = 166) was achieved for the fluorescein internal standard.

[Developments of High-Throughput Microfluidic Sample Introduction Techniques].

High-Throughput Microfluidic Sample Introduction In The Nanoliter To Picoliter Range

Microfluidic chip-based flow-injection analysis with high throughput sampling interface

Sample Introduction Techniques For Microfluidic Chip-Based Capillary Electrophoresis

A High-Throughput Continuous Sample Introduction Interface for Microfluidic Chip-Based Capillary Electrophoresis Systems.

Recent progress of microfluidic sample preparation techniques

Recent Advances in the Determination of Intracellular Contents in Individual Cells Using Microfluidic Devices

High-throughput sample introduction for droplet-based screening with an on-chip integrated sampling probe and slotted-vial array.

Fabricating Technologies of Nanofluidic Chips and Their Applications

Design of a high-throughput integrated microfluidic chip combining micromixing and particle sorting functions

Recent Development of Microfluidic Diagnostic Technologies

Developments And Applications Of Microfluidic Chip-Based Chromatographic Technique

Improvements on the electrokinetic injection technique for microfluidic chips

Sample preparation for single cell sequencing on integrated microfluidic devices

Design and Preparation of Microfluidics Device

Design and Testing of Micro Fluidic Chemical Analysis Chip Integrated with Micro Valveless Pump

Application of Microfluidics in Immunoassay: Recent Advancements

Development Of Integrated Capillary Electrophoresis Chips Technology

Recent Developments in Microfluidic Chip for in vitro Cell-based Research

Fabrication of a Monolithic Sampling Probe System for Automated and Continuous Sample Introduction in Microchip‐based CE

Recent Development in Microfluidic Chips for in Vitro Cell-based Research