Abstract:Compared with silicon and silicon carbide devices, the unique electrical and structural characteristics of gallium nitride high electron mobility transistors (GaN HEMTs) make them have different requirements for power module integration. This article proposes a novel integration scheme for the high-voltage lateral GaN HEMT dies without bonding wires. Based on the proposed integration scheme, a compact 650 V/30 A GaN power module with low parasitic parameters and high thermal performance is designed. The GaN dies are sandwiched between two ceramic substrates to improve thermal performance and ensure consistent thermal expansion coefficients. The multiple copper layer structure is used to increase wiring flexibility to reduce parasitic parameters. The design of gate and power loop layouts is discussed, and the common-mode (CM) capacitance is optimized. A comprehensive reliability evaluation is also carried out for this integration scheme. Finally, a double-sided cooling 650 V/30 A full-bridge GaN power module with 2.4 cm×1.3 cm×0.17 cm is fabricated. The thermal resistance is reduced by 30%–48% compared with the conventional single-sided cooling module. The power loop and gate loop inductances are reduced to 0.94 nH and 2 nH, respectively, and the CM capacitance is limited to 2.5 pF. The maximum dv/dt of the drain–source voltage is high as 150 V/ns with only 10% overshoot. Based on the power module, a 3.3-kW two-phase interleaved buck converter is developed. It has 820 W/in3 power density and 98.85% peak efficiency.

An Optimized Layout with Split Bus Capacitors in Egan-Based Integrated DC-DC Converter Module

An optimized layout with low parasitic inductances for GaN HEMTs based DC-DC converter

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

A High Frequency High Efficiency GaN Based Bi-Directional 48V/12V Converter with PCB Coupled Inductor for Mild Hybrid Vehicle

Study On Planar Busbar Regarding Stray Inductance Minimization And Oscillation Suppression For High Power Converter

Ultra-Low Inductance Design for A Gan Hemt Based 3L-Anpc Inverter

Three Dimensional Integration of GaN-HEMT-based DC-DC Converter Using Planar Inductor As a Substrate

Analysis of A Low-Inductance Packaging Layout for Full-Sic Power Module Embedding Split Damping

A Gallium Nitride Integrated Power Module with Ultra-low Parasitic Inductances and Thermal Resistance

A Compact Double-Sided Cooling 650V/30A GaN Power Module With Low Parasitic Parameters

Modeling and Design of Integrated Inductor and Transformer Considering Superposed Flux Density in On-Board-Charger

A Double-Sided Cooling 650V/30A GaN Power Module with Low Parasitic Inductance

A Layout Optimization Method to Reduce Commutation Inductance of Multi-Chip Power Module Based on Genetic Algorithm

Advantages for Embedding DC-link Decoupling Capacitance in High Capacity Power Electronic Converters

Design Considerations of an Isolated GaN Bidirectional Dc-Dc Converter

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Study And Design Of Noninductive Bus Bar For High Power Switching Converter

A Highly Integrated GaN Power Module with Low Parasitic Inductance and High Thermal Performance

Current Sharing Analysis and Evaluation of Parallel DC-Link Capacitors in Vehicle Motor Drive

Understanding the Effect of PCB Layout on Circuit Performance in a High-Frequency Gallium-Nitride-Based Point of Load Converter

Optimized Design of Laminated Busbar for Large-Capacity Back-to-Back Converters