Abstract:Silicon oxynitride (SiON) is an important material to fabricate micro-electro-mechanical system (MEMS) devices due to its composition-dependent tunability in electronic and mechanical properties. In this work, the SiON film with 41.45% silicon, 32.77% oxygen and 25.78% nitrogen content was deposited by RF magnetron sputtering. Two types of optimized micro-structures including micro-cantilevers and micro-rotating-fingers were designed and fabricated using MEMS surface micromachining technology. The micro-cantilever bending tests were conducted using a nanoindenter to characterize the Young's modulus of the SiON film. Owing to the elimination of the residual stress effect on the micro-cantilever structure, higher accuracy in the Young's modulus was achieved from this technique. With the information of Young's modulus of the film, the residual stresses were characterized from the deflection of the micro-rotating-fingers. This structure was able to locally measure a large range of tensile or compressive residual stresses in a thin film with sufficient sensitivities. The results showed that the Young's modulus of the SiON film was 122GPa and the residual stresses of the SiON film were 327MPa in the crystallographic orientation of the wafer and 334MPa in the direction perpendicular to the crystallographic orientation, both in compression. This work presents a comprehensive methodology to measure the Young's modulus and residual stresses of a thin film with improved accuracy, which is promising for applications in mechanical characterization of MEMS devices.

Characterization Of Elastic Properties Of Sio2 Thin Films By Ultrasonic Microscopy

Evaluation of Elastic Properties of Sio2 Thin Films by Ultrasonic Microscopy

Properties of plasma-deposited amorphous SiO2 films

Thickness Dependence of Properties of Plasma-Deposited Amorphous SiO2 Films

Study of plasma-deposited amorphous SiO2 films using infrared absorption techniques

Optical and Mechanical Properties and Microstructures of Nb2O5, Ta2O5 and SiO2 Thin Films Prepared by Ion Beam Sputtering

Deposition of Dense SiO2 Thin Films for Electrical Insulation Applications by Microwave ECR Plasma Source Enhanced RF Reactive Magnetron Sputtering

Characterizations of Elastic Constants of Transparent Thin Films Deposited on Substrates by Laser Ultrasonic Method

Photothermal Elastic Vibration Spectra of SiO2 Film on Si

Study on elastic modulus of ultra-thin copper films by in-situ SEM-SPM nanoindentation

Correlation Between Temperature Coefficient of Elasticity and Fourier Transform Infrared Spectra of Silicon Dioxide Films for Surface Acoustic Wave Devices

Investigation of Elastic Properties of WO3 Thin Films Supported on Quartz in Surface Acoustic Wave Sensing Devices

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Mechanical Properties of Mono-crystalline Silicon Thin Films Measured by Different Methods

A Novel Technique for Mechanical Characterization of Thin Elastomeric Membrane

Characterization of the Mechanical Properties of Microscale Elastomeric Membranes

Ultra-sensitive, Highly Reproducible Film Stress Characterization Using Flexible Suspended Thin Silicon Plates and Local Curvature Measurements

High-accuracy standard specimens for the line-focus-beam ultrasonic material characterization system

Characterization of the Young's Modulus and Residual Stresses for a Sputtered Silicon Oxynitride Film Using Micro-Structures

Ellipsometric Study of the Optical Properties of Silicon-Based Si : Sio2 Composite Thin Films under Different Annealing Temperatures

Measurement Technique for Elastic and Mechanical Properties of Polycrystalline Silicon-Germanium Films Using Surface Acoustic Waves and Projection Masks