Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

A Single Pulse Charge Pumping Technique for Fast Measurements of Interface States

Development of a Fast Technique for Characterizing Interface States

A New Charge-Pumping Measurement Technique for Lateral Profiling of Interface States and Oxide Charges in MOSFETs

Charge Pumping Measurement for Determing Band-to-Band-Tunneling Induced Interface Damage During Erasing Operation of FLASH

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

A modified charge-pumping method for the cxharacterization of interface-trap generation in MOSFETs

Integration of on-chip field-effect transistor switches with dopantless Si/SiGe quantum dots for high-throughput testing

A New Ultra-Fast Single Pulse Technique (UFSP) for Channel Effective Mobility Evaluation in MOSFETs

A Discharge-Based Pulse Technique for Probing the Energy Distribution of Positive Charges in Gate Dielectric

Development of new characterisation technique for interface states beyond bandgap

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.

Measurement of Energetic and Lateral Distribution of Interface State Density in Fully-Depleted Silicon on Insulator Metal-Oxide-Semiconductor Field-Effect Transistors

A Fast DCIV Technique for Characterizing the Generation and Repassivation of Interface Traps under DC/ AC NBTI Stress/Recovery Condition in Si P-Finfets

Implementation of a No Pulse Competition CPS-SPWM Technique Based on the Concentrated Control for Cascaded Multilevel DSTATCOMs

On-The-Fly Interface Trap Measurement And Its Impact On The Understanding Of Nbti Mechanism For P-Mosfets With Sion Gate Dielectric

A new technique for probing the energy distribution of positive charges in gate dielectric

Fast characterization of multiplexed single-electron pumps with machine learning

Experimental Evidence Toward Understanding Charge Pumping Signals in 3-D Devices with Poly-Si Channel

Improved On-Chip Self-Triggered Single-Event Transient Measurement Circuit Design and Applications

Rapid Detection of Capture and Emission Processes in Surface and Buffer Traps: Understanding Dynamic Degradation in GaN Power Devices

An FPGA Based Fast Linear Discharge Method for Nuclear Pulse Digitization