Abstract:This paper presents a noncontact sliding table design and measurements of its performance via ultrasonic levitation. A slider placed atop two vibrating guide rails is levitated by an acoustic radiation force emitted from the rails. A flexural traveling wave propagating along the guide rails allows noncontact transportation of the slider. Permitting a transport mechanism that reduces abrasion and dust generation with an inexpensive and simple structure. The profile of the sliding table was designed using the finite-element analysis (FEA) for high levitation and transportation efficiency. The prototype sliding table was made of alumina ceramic (Al2O3) to increase machining accuracy and rigidity using a structure composed of a pair of guide rails with a triangular cross section and piezoelectric transducers. Two types of transducers were used: bolt-clamped Langevin transducers and bimorph transducers. A 40-mm long slider was designed to fit atop the two rail guides. Flexural standing waves and torsional standing waves were observed along the guide rails at resonance, and the levitation of the slider was obtained using the flexural mode even while the levitation distance was less than 10 microm. The levitation distance of the slider was measured while increasing the slider's weight. The levitation pressure, rigidity, and vertical displacement amplitude of the levitating slider thus were measured to be 6.7 kN/m2, 3.0 kN/microm/m2, and less than 1 microm, respectively. Noncontact transport of the slider was achieved using phased drive of the two transducers at either end of the vibrating guide rail. By controlling the phase difference, the slider transportation direction could be switched, and a maximum thrust of 13 mN was obtained.

Design and Implementation of a Miniature Polymer Ball Bearing Slide Table

Design and Implementation of an On-Chip Polymer Micro Ball Bearing

Design of a Novel Air Bearing Workbench for Rotary Ultrasonic Drilling of Advanced Ceramics

Fabrication and Analyses of Bionic Polymer Lens System

An ultrasonically levitated noncontact stage using traveling vibrations on precision ceramic guide rails

Design and Experimental Validation of a Linear Piezoelectric Micromotor for Dual-Slider Positioning

A Miniaturized Dual-Slider Linear Actuator Using Electrostatic Adhesion and Inertia Drive

Development of a Suspension Type Sliding Planar Motion Table Using Magnetic Fluid Lubrication

Implementation of a micro ball lens on a silicon optical bench using insoluble two-phase liquid immersion technology

Fabrication and Flying Test of Silicon Sliders

An innovative graphite sliding bearing for substation structures

The Light-Fueled Self-Rotation of a Liquid Crystal Elastomer Fiber-Propelled Slider on a Circular Track

Design, Control of an Aerostatic X-Y Planar Motion Stage for Precision Positioning

Engineering and performance of a contactless linear slider based on superconducting magnetic levitation for precision positioning

Design and Fabrication of the Lubricating Dimple of the Headface Sliding Bearing with Phyllotactic Pattern

Research on the Design and Fabrication of Air Bearing Sliders in Hard Disk Drives

Patterned Liquid Micro Rails for the Transport of Micrometer Sized Chips

Non-contact linear slider for cryogenic environment

Formation and Integration of a Ball Lens Utilizing Two Phase Liquid Technology

Improving Resolution and Run Outs of a Superconducting Noncontact Device for Precision Positioning

Shape memory alloy (SMA)-cable-controlled sliding bearings: development, testing, and system behavior