Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

Design and Fabrication of the Lubricating Dimple of the Headface Sliding Bearing with Phyllotactic Pattern

Optimal design of micro-dimples on crankpin bearing surface for improving engine’s lubrication and friction

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Effects of Surface Waviness and Dimple on Elastohydrodynamic Lubrication

Surface Texturing for Low Friction Mechanical Components

Experimental Study on the Effect of Micro-Texture on EHL Point-Contact Film Thickness Subject to Sliding Conditions

Effect of Micro-Dimple Geometry on the Tribological Characteristics of Textured Surfaces

Enhancement of lubricant replenishment for starved lubrication by laser-induced wettability gradient surface

Theoretical and experimental study on influences of surface texture on lubrication performance of a novel bearing

Wedge-shaped lyophilic pattern on superlyophobic surface for unidirectional liquid guidance and lubrication enhancement

Influence of different loads and temperatures on solid lubricant-filled micro-dimples existing on both cylinder liner and piston ring

Method of Enhancing Lubrication Performance of the Engine Based on Optimal Dimples of Partial Textures

Influence of Microdimple on Lubrication Performance of Textured Plunger Pump

Evaluation and Optimization of Axial Piston Pump Textured Slipper Bearings with Spherical Dimples Based on Hybrid Genetic Algorithm

Study of offset factor and depths of dimple on the performance of two-lobe journal-bearings

Optimizing the Parameters of the Partial Textures of the Crankpin Bearing to Enhance the Lubrication Performance of an Engine

Effect of Micro-Dimple Texture on the Tribological Performance of Brass with Titanium Nitride (TiN) Coating under Oil-Lubricated Conditions

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Numerical analysis of lubrication properties on a bio-inspired parabolic textured surface

Analysis of the lubrication process with composition of solid lubricants of laser-modified sliding surfaces

Investigation of the Effect of Milli-Scale Dimples on Planar Contact Lubrication