Abstract:Purpose The purpose of this study is to investigate the influence of dimple radius, depth and density on the lubrication performance of the plunger. Design/methodology/approach A lubrication model was adopted to consider eccentricity and deformation during the working process of the plunger, and a rig test was performed to confirm the simulation results. The texture was fabricated using laser surface texturing. Findings The simulation results suggested that when dimple radius or depth increases, oil film thickness of the plunger increases before decreasing, and asperity friction displays an opposite trend. Therefore, appropriate microdimple texture could facilitate lubrication performance improvement and reduce the wear. Microdimples were then lased on the plunger surface, and a basic tribological test was conducted to validate the simulation results. The experimental results suggested that the average friction coefficient decreased from 0.18 to 0.13, a reduction of 27.8%. Social implications The introduction of microdimple on a plunger couple to reduce friction and improve lubrication is expected to provide a new approach to developing high-performance plunger couple and improve the performance of the internal combustion engine. If applied, the surface texture could help reduce friction by around 27% and cap the cost relative to the plugger friction. Originality/value The microdimple texture was introduced into the plunger couple of a vehicle to reduce the friction and improve the performance. Findings suggested that surface texture could be used in the automotive industry to improve oil efficiency and lubrication performance. Peer review The peer review history for this article is available at: http://dx.doi.org/10.1108/ILT-07-2020-0259.

Optimal design of micro-dimples on crankpin bearing surface for improving engine’s lubrication and friction

Design and optimization of textures on the surface of crankpin bearing to improve lubrication efficiency and friction power loss of engine

Optimizing the Parameters of the Partial Textures of the Crankpin Bearing to Enhance the Lubrication Performance of an Engine

Method of Enhancing Lubrication Performance of the Engine Based on Optimal Dimples of Partial Textures

Design and Fabrication of the Lubricating Dimple of the Headface Sliding Bearing with Phyllotactic Pattern

Lubrication efficiency of crankpin bearing using square-cylindrical textures of partial textures optimized by genetic algorithm

Optimization Design Of The Inner Radius Of The Sealing Surface Of Slipper

Multi-objective Optimization of Micron-Scale Surface Textures for the Cylinder/valve Plate Interface in Axial Piston Pumps

Lubricating Simulation Analysis of Connecting Rod Bearing Based on AVL-EXCITE

Effects of Hyperelliptic Bearings Bush on Connecting Rod Big-End Lubrication and Design Optimization

Study on the effects of the textured surface to improve the performance of cylinder block/valve plate interfaces

Optimization and Influence of Micro-Chamfering on Oil Film Lubrication Characteristics of Slipper/Swashplate Interface Within Axial Piston Pump

Influence of Microdimple on Lubrication Performance of Textured Plunger Pump

Lubrication Analysis of Small-End Bearings of Reciprocating Engines Based on Orthogonal Experiment

CFD Analysis of the Effect of Dimples and Cylinder Liner Honing Groove on the Tribological Characteristics of a Low Displacement Engine

Simulation Study on Bearing Lubrication Mechanism and Friction Characteristics of the Biomimetic Non-Smooth Surface of a Cross-Scale, Second-Order Compound Microstructure

Numerical Investigation of the Tribological Performance of Micro-Dimple Textured Surfaces under Hydrodynamic Lubrication

Parametric Design of Surface Textures on Journal Bearing

Improving engine's lubrication based on optimised partial micro-textures

The Analysis of Lubrication Properties of Crankshaft Main Bearing on Diesel Engine