Abstract:In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on bias current. The unique behaviour of the MOS transistors in subthreshold region not only allows a designer to work at low input bias current but also at low voltage. While operating the device at weak inversion results low power dissipation but dynamic range is degraded. Optimum balance between power dissipation and dynamic range results when the MOS transistors are operated at moderate inversion. Power is again minimised by the application of input dependant bias current using feedback loops in the input transistors of the differential pair with two current substractors. In comparison with the reported low power low voltage opamps at 0.8 micron technology, this opamp has very low standby power consumption with a high driving capability and operates at low voltage. The opamp is fairly small (0.0084 mm 2) and slew rate is more than other low power low voltage opamps reported at 0.8 um technology [1,2]. Vittoz at al [3] reported that slew rate can be improved by adaptive biasing technique and power dissipation can be reduced by operating the device in weak inversion. Though lower power dissipation is achieved the area required by the circuit is very large and speed is too small. So, operating the device in moderate inversion is a good solution. Also operating the device in subthreshold region not only allows lower power dissipation but also a lower voltage operation is achieved.

A 120dB input dynamic range, current-input current-output CMOS logarithmic amplifier with 230ppm/°K temperature sensitivity

Design of a Programmable Gain, Temperature Compensated Current-Input Current-Output CMOS Logarithmic Amplifier.

The Design of a Low-Voltage Rail-to-Rail CMOS Operational Amplifier

A Wideband BiCMOS Thermal Noise Canceling Low Noise Amplifier with Temperature Compensation

A 0.26-Pj·k2 2400-Μm2 Digital Temperature Sensor in 55-Nm CMOS

An Untrimmed BJT-Based Temperature Sensor with Dynamic Current-Gain Compensation in 55-Nm CMOS Process

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

A Dynamic-Biased Resistor-Based CMOS Temperature Sensor with a Duty-Cycle-Modulated Output

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 1770- $\mu$ M 2 Leakage-Based Digital Temperature Sensor with Supply Sensitivity Suppression in 55-Nm CMOS

Design of Logarithmic Current Amplifier for Micro-Pcr EC Detection

A Novel Differential Log-Companding Amplifier for Biosignal Sensing

A Low-Power CMOS Rail-to-Rail Input/Output Constant-Gm Operational Amplifier

Design of A Low Power Low Voltage CMOS Opamp

A Wideband Logarithmic-like Amplifier Based on 65-nm CMOS Process

A 20 nW+0.8 C/-0.8 C Inaccuracy (3) Leakage-Based CMOS Temperature Sensor With Supply Sensitivity of 0.9 C/V

A Research and Design of High Performance CMOS Integrated Operational Amplifier

A High-Gain Wide-Band Common-Gate CMOS Current-Mode Amplifier

A Low Power Temperature-Compensated Common-Mode Voltage Detector for Dynamic Amplifiers.

Design of Low-Offset Low-Power CMOS Amplifier for Biosensor Application