Abstract:A 16bit 125Msps pipelined analog-to-digital converter (ADC) critical front-end stage supporting variable input common-mode voltage in 0.18um CMOS process is designed in this paper. The difference between the common-mode voltage of the input signal and the one of the reference causes the summing node of the residue amplifier to deviate from the appropriate voltage. To make the ADC support wide input common-mode voltage from 0.6V to 1.3V, the common-mode refreshing technique is proposed. The summing node is floating when the method is employed. To make the amplifier not disturbed and recover quickly, the dynamic biasing technique is applied to turn off the amplifier when the system is in the sampling phase. Offset calibration is employed in the sub-ADC to reduce comparator’s offset. The designed ADC achieves 90.7 dBc spurious-free dynamic range (SFDR), 79.5 dBFS signal-to-noise-and-distortion ratio (SNDR) under 70MHz input signal with 0.8V input common-mode voltage. The ability of supporting wide input common-mode voltage is proven by simulation.

Research and Design of Wide Input Common-Mode Range Current-Sense Amplifier

Design of High-Side Current Sense Amplifier with Ultra-Wide ICMR

A novel current-mode instrumentation amplifier with Rail-to-Rail input and output

Research and design of high accuracy high-side current sense amplifier

The Design of a Low-Voltage Rail-to-Rail CMOS Operational Amplifier

A current reference based on bandgap technology with wide input voltage range by using 0.18µm BCD process

A High Accuracy and Wide Input Voltage Range Current Sense Amplifier for Bidirectional High-Side and Low-Side Current-Sensing

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

High precision amplifier used for high-side current sensing

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

A Differential Compensated Air Coil Current Sensor for Switching Current Measurement of Power Devices.

Design and Implementation of Ultralow Current-Mode Amplifier for Biosensor Applications

Design of Novel Current-Mode Sense Amplifier in Large Scale Srams

Design and Verification of Ultra Low Current Mode Amplifier Aiming at Biosensor Applications

A Wide Input Common-mode Range Pipelined ADC Front-end with Common-mode Refreshing

An Error Amplifier with Wide Input Common Mode Voltage Range for HBWLED Driver

Low gain-error instrumentation amplifier for current sensing

A 3.6V Rail-to-Rail Operational Amplifier with Constant G M

A High Dynamic Range Ultralow-Current-mode Amplifier with Pico-Ampere Sensitivity for Biosensor Applications

Design and Implementation of Ultra Low Current Sensing Amplifier with Pico-Ampere Sensitivity Aiming at Bio-Sensor Applications

Design of Common-Mode Feedback for High-Gain Charge Amplifier