Abstract:This paper develops a one-dimensional simulation model of a thermoelectric module aiming at its characteristic exploration and output performance prediction. Almost all related effects are considered including Seebeck, Peltier, Thomson effects, the spatial- and temperature-dependent thermoelectric material properties, as well as the other irreversible factors. In order to ensure its high accuracy and computational efficiency, the differential equations built for components of non-linear physical properties, and analytical equations for the others of constant properties are jointly solved by numerical methods and implemented in MATLAB integrated development environment. A small deviation of 1.44% exists between its calculated output power and that by a previously reported three-dimensional model under a specific wide load range (0-250 Omega), validating its accuracy of this model. Besides, it indicates that both the proportions of heat leakage through the occupied air zone and its maximum output power to the input total heat flow have the same order of magnitude. A rising proportion for the former has to be paid attention in case of a higher temperature difference applied. The assumption of regarding its electrical contact resistance as an identical external resistance connected with the load in series is computationally proved to generate a negligible discrepancy in terms of TEM characteristics and its output performance. Furthermore, with respect to the impacts of TEM geometry, the pre-set fixed substrate area weakens the equivalence of regarding a thermoelectric module with larger cross-section area of thermoelectric legs as multiple identical modules with smaller leg areas connected in parallel. It accounts for the better linearity of rising output power by a long leg than that by a short leg as the leg area increases. A long thermoelectric leg means an increased induced electrical potential and inner resistance as well, thus leading to a single peak of the output power as the leg length increases. Finally, a thermoelectric geometric optimization approach abased on the Hill-climbing algorithm is introduced and first applied for the maximum output. Its accuracy and efficiency are validated and analyzed detailedly by supplying different variables as initial search point. All the methods and conclusions in this paper can assist thermoelectric generators' performance estimation and guide the geometric optimizations regarding their large-scale applications in the future.

Design and Modeling of Vacuum Packaged MEMS Thermoelectric Power Generator Using Heat Dissipation Path

Design and Optimization of Wafer Bonding Packaged Microelectromechanical Systems Thermoelectric Power Generators with Heat Dissipation Path

Development of vacuum packaged CMOS thermoelectric energy harvester

Wafer-level vacuum sealing and encapsulation for fabrication of CMOS MEMS thermoelectric power generators

Design, Fabrication, and Characterization of CMOS MEMS-Based Thermoelectric Power Generators

Seal and Encapsulate Cavities for Complementary Metal-Oxide-Semiconductor Microelectromechanical System Thermoelectric Power Generators

Numerical Modeling of the Performance of Thermoelectric Module with Polydimethylsiloxane Encapsulation

MODELING AND OPTIMAL DESIGN FOR MICRO-THERMOELECTRIC GENERATOR

Manufacturing and Measurement of CMOS-MEMS-Based Micro Thermoelectric Generators with Long-Length Thermocouples

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Modeling, properties, and fabrication of a micromachined thermoelectric generator

Heat Exchanger Design for A Thermoelectric Module to Drive Wireless Sensors in Spindle Monitoring

Design and Fabrication of Wearable Thermoelectric Generator Device for Heat Harvesting

Measurement and Analysis for Performance of Micro-thermoelectric Generator

A Physical Model for Thermoelectric Generators With and Without Thomson Heat

Modeling of Thermoelectric Generators with Effects of Side Surface Heat Convection and Temperature Dependence of Material Properties

Elucidating modeling aspects of thermoelectric generator

Numerical Study on Nonuniform Segmented Enhancement Method for Thermoelectric Power Generator

Experiments and Modeling on Thermoelectric Power Generators Used for Waste Heat Recovery from Hot Water Pipes

Comprehensive Modeling for Geometric Optimization of a Thermoelectric Generator Module