Abstract:COMSOL Multiphysics software-based three-dimensional finite element analysis is widely used in the performance simulation of thermoelectric devices. In this study, this software is used to simulate the heat transfer processes and power generation performance of micro-thermoelectric generators based on a microporous glass template. The temperature and electrical potential fields are coupled to each other through the thermoelectric effects during the calculations. The power generation performances of micro-thermoelectric generators with different template heights (d) for various temperature differences between their hot and cold ends (∆Th-c) are calculated. For the micro-thermoelectric generator that included four pairs of TE couples, the temperature difference between the two sides of the TE columns (∆TTE) and the open circuit voltage (Uoc) both increased with increasing d, but the growth rate gradually decreased. When d is greater than 0.2 mm, the increment basically becomes negligible. The maximum output power (Pmax) first increases and then decreases with increasing d, reaching a maximum value when d is 0.2 mm. Therefore, we can optimize the size of device according to the simulation results to ensure that the device produces the optimal output performance during the experiments. A model with the same parameters used in the experiment (i.e., d=0.2 mm) was then established and it generated a Uoc of 35.2 mV and a Pmax of 228.8 μW when ∆Th-c was 107.5 K (∆TTE = 97.55 K). The errors between the simulation and the experimental results are small and thus also verify the accuracy of the power generation performance test results.

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Measurement and Analysis for Performance of Micro-thermoelectric Generator

MODELING AND OPTIMAL DESIGN FOR MICRO-THERMOELECTRIC GENERATOR

Accurate Mode and Analysis for Micro-thermoelectric Generate Device

Modeling and Simulate Analysis for Micro-Thermoelectric Generator

THE APPLICATION RESEARCH OF HEAT SOURCE AND HEAT SINK IN MICRO (MINI) THERMOELECTRIC DEVICE

Measurement and analysis for performance of micro-thermoelectric generate device with liquid fuel

Finite Element Simulation of Micro-Thermoelectric Generators Based on Microporous Glass Template

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Study of Different Heat Exchange Technologies Influence on the Performance of Thermoelectric Generators

Performance analysis of a novel Two-stage automobile thermoelectric generator with the Temperature-dependent materials

A Physical Model for Thermoelectric Generators With and Without Thomson Heat

Thermoelectric Performance Evaluation and Optimization in a Concentric Annular Thermoelectric Generator under Different Cooling Methods

Analysis of the generating ability of the thermoelectric conversion device

Study of Thermal Insulation Materials Influence on the Performance of Thermoelectric Generators by Creating a Significant Effective Temperature Difference

Research Summarization on Micro Thermoelectric Generator

Manufacturing and Measurement of CMOS-MEMS-Based Micro Thermoelectric Generators with Long-Length Thermocouples

Theoretical analysis of shape factor on performance of annular thermoelectric generators under different thermal boundary conditions

Performance Analysis on a Solar Concentrating Thermoelectric Generator Using the Micro-Channel Heat Pipe Array

Efficiency analysis of thermoelectric generators

Performance Investigation and Optimization of an L-type Thermoelectric Generator