Abstract:<p>In practical applications, the thermoelectric module (TEM) conducts continuous heat exchange with the external environment. This causes uneven temperature distribution inside the module and some PN legs do not work effectively. The internal heat transfer direction of the TEM changes under the influence of the environment, resulting in energy loss and an inability to transfer heat in a consistent direction. In this study, the actual working environment of the TEM was simulated by a constant temperature heating platform, and we analyzed the heat transfer characteristics of the module using numerical calculation methods. Then, according to the results of this analysis, a sealed thermoelectric module (STEM) filled with high-temperature vulcanized silicone rubber (HTV) was designed. Besides, to improve the practicality of the STEM, we designed an integrated thermoelectric (TE) plate. The TE plate was equipped with a controllable water-cooling device, which allowed adjustments of the TEM cold end temperature according to the heat source to ensure maximum output power. Results indicated that the STEM can reduce heat exchange behavior at the edges and ensure uniform temperature distribution throughout the module. The maximum temperature gradient at the cold end of the STEM is 4.39 °C, which is 5.27 °C lower than the equivalent value of the TEM. Therefore, the temperature gradient in each of the PN legs in the STEM is similar, which can reduce the electrical loss generated by itself. We implemented a closed structure on the TE plate, and the internal circuit was installed on the contact surface of the water-cooling device to ensure that the circuit was not damaged due to the influence of the thermal environment. When the heat source temperature was 200 °C, the TE plate adopted a two-stage water-cooling mode to deliver a maximum output power of 78.64 W, which equates to a power generation per unit area of 0.86 kW·h/m<sup>2</sup>. The TEM structure optimization and TE plate design scheme proposed in this study provides an efficient solution for the practical application of TE technology.</p>

Design and Optimization of Wafer Bonding Packaged Microelectromechanical Systems Thermoelectric Power Generators with Heat Dissipation Path

Design and Modeling of Vacuum Packaged MEMS Thermoelectric Power Generator Using Heat Dissipation Path

Development of vacuum packaged CMOS thermoelectric energy harvester

Wafer-level vacuum sealing and encapsulation for fabrication of CMOS MEMS thermoelectric power generators

Design, Fabrication, and Characterization of CMOS MEMS-Based Thermoelectric Power Generators

Seal and Encapsulate Cavities for Complementary Metal-Oxide-Semiconductor Microelectromechanical System Thermoelectric Power Generators

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Design and Fabrication of Wearable Thermoelectric Generator Device for Heat Harvesting

Wearable Thermoelectric Generator with Copper Foam As the Heat Sink for Body Heat Harvesting

Bilayer Y-Type Transverse Thermoelectric Generator with Non-contact Vertical Thermal Coupling using LTCC Technology

Impact of internal connections and heat loss on simulated large-scale low-temperature thermoelectric generation system

Development and Optimization of High Power Density Micro-Thermoelectric Generators

Design a new thermoelectric module with high practicability based on experimental measurement

Simultaneous Realization of Flexibility and Ultrahigh Normalized Power Density in a Heatsink-Free Thermoelectric Generator via Fine Thermal Regulation

Experimental Investigation for a Novel Prototype of a Thermoelectric Power Generator With Heat Pipes

Manufacturing and Measurement of CMOS-MEMS-Based Micro Thermoelectric Generators with Long-Length Thermocouples

A Thermoelectric Generation System and Its Power Electronics Stage

Thermal management of a flexible controlled thermoelectric energy conversion-utilization system using a multi-objective optimization

Optimization Design and Performance Study of Wearable Thermoelectric Device Using Phase Change Material as Heat Sink

High-Performance Wearable Bi2Te3-Based Thermoelectric Generator

Performance enhancement of a novel thermoelectric self-cooling system for electronic devices