Abstract:Bi 2 Te 3 -based materials can be assembled into promising thermoelectric generators (TEGs) used for room temperature applications, yet their regulation for a wide range of applications, like the Internet of Things (IoTs), is limited by the small open circuit voltage, poor output power and large energy loss resulting from parasitic depletion to some extent. In this work, we have fabricated high-density thermoelectric generators (HD-TEGs) to compensate for these shortages, and the boosted voltage could reduce the energy loss simultaneously. To integrate HD-TEGs, the fabrication processes manipulate electrode deposition and reflow soldering techniques of delivering micro- and bulk-TEGs. Subsequently, a normalized power density of ∼13.7 μW cm −2 K −2 , along with an open circuit voltage of ∼1.9 V, calculated contact depletion of ∼36% and experimental circuit depletion of ∼5% at Δ T of 13 K, has been achieved in a HD-TEG with 338 thermocouples (Tcs). Upon increasing Δ T to 73 K, the open circuit voltage and maximum output power are ∼10.1 V and 843.2 mW, which exceed those of the 50-Tcs TEG with packing fraction ( f ) of 5% and 34%, as well as the 200-Tcs TEG ( f = 20%). These conversion properties are even much better than those of most commercial TEGs. Further, the finite-element simulation data indicate that output power and open circuit voltage could be further optimized to ∼68.5 mW (25.4 μW cm −2 K −2 ) and ∼2.9 V at Δ T of 13 K, by further increasing the density of thermoelectric elements and reducing contact loss. Moreover, our study elucidates that fabricating TEGs by using a high-density approach, i.e. , optimizing packing fraction by increasing the quantity of thermocouples, could be an effective avenue for achieving high output performance with superior critical voltage and small energy loss.

Development and Optimization of High Power Density Micro-Thermoelectric Generators

MODELING AND OPTIMAL DESIGN FOR MICRO-THERMOELECTRIC GENERATOR

A High Power Density Micro-Thermoelectric Generator Fabricated by an Integrated Bottom-Up Approach

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Design and Fabrication of Microarchitected Thermoelectric Generators: Prospects and Challenges

Measurement and Analysis for Performance of Micro-thermoelectric Generator

THE APPLICATION RESEARCH OF HEAT SOURCE AND HEAT SINK IN MICRO (MINI) THERMOELECTRIC DEVICE

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Design, Fabrication, and Characterization of CMOS MEMS-Based Thermoelectric Power Generators

Optimizing the output performance and parasitic depletion of Bi2Te3-based thermoelectric generators by using a high-density approach

Design and Optimization of Wafer Bonding Packaged Microelectromechanical Systems Thermoelectric Power Generators with Heat Dissipation Path

Towards high integration and power density: Zigzag-type thin-film thermoelectric generator assisted by rapid pulse laser patterning technique

Energy Conversion Using New Thermoelectric Generator

Fabrication and characterization of ultrathin thermoelectric device for energy conversion

Research Summarization on Micro Thermoelectric Generator

High Power Density Micro Thermoelectric Generators for Powering IoTs

Three dimensional architected thermoelectric devices with high toughness and power conversion efficiency

Recent developments of thermoelectric power generation

High-performance thermoelectrics and challenges for practical devices

Optimization of the geometric parameters and structural design of a flexible thermoelectric generator for efficient energy harvesting to power wearable electronics

Thermoelectric power generation: from new materials to devices