Abstract:The miniaturization of integrated circuits has led to a shift in lead frame fabrication methods from physical stamping to chemical etching. However, this process is highly sensitive to residual stress. We investigated the gradient distribution of residual stress, microstructure, and macroscopic texture in electronic copper foils using a layer-by-layer peeling method, and proposed a novel strategy for evaluating residual stress levels. Our findings reveal that the rolling-induced residual stress exhibits a gradient distribution along the thickness direction. Specifically, from the surface to the central layer, the stress transitions gradually from tensile to compressive, with the stress type primarily influenced by metal flow during rolling. Additionally, we observed gradient variations in the S and Cube texture. Tensile stress favors the formation of Cube-texture, while compressive stress promotes S-texture development. Notably, Cube-texture can lead to strain localization during rolling, directly impacting the local residual stress levels and distribution. Furthermore, quantitative analysis of dislocation density using peak profile methods revealed a consistent trend between {111} plane dislocation density and lateral residual stress. Further investigation highlighted that dislocations and precipitates associated with {111} planes in face-centered cubic metals significantly influence residual stress, with their combined effects determining the overall stress magnitude in relation to texture, dislocations, and precipitates.

Stress analysis of interconnect structure in COF by finite element method

Simulation and Experimental Analysis of Thermomechanical Stress Around Interconnects for W2W Hybrid Bonding

Study of Local Stress Using Stress-Absorbing Si Diaphragm

The Influence of Solder on the Thermal Stress in a FCOL Device

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

A Framework for Layout-Dependent STI Stress Analysis and Stress-Aware Circuit Optimization

Stress Analysis of Cu/low-k Interconnect Structure During Whole Cu-CMP Process Using Finite Element Method.

Residual Stress Assessment of Interconnects by Slot Milling with Fib and Geometric Phase Analysis

Evaluation of the Effect of Stress Relief Slots on QFN Strip Warpage Using Finite Element Analysis

Thermal Stress and Reliability Analysis of TSV-Based 3-D ICs with a Novel Adaptive Strategy Finite Element Method

Experimental and Numerical Studies of Stress Migration in Cu Interconnects Embedded in Different Dielectrics

An Efficient Finite-Element Method-Based Stress Simulator for Integrated Circuit Optimization Designs

Thermal Finite Element Simulation of Ultrafine Pitch Chip-to-Wafer Hybrid Bonding

Thermal Stress Analysis for the Low-k Dielectric Layers of Cu Interconnects in a 45 nm Chip

Stress Modeling for the Impacts of Flip Chip Process on the Ultralow-K Chips

Evaluating Interface Effect On Stresses In Thin Films By A Local Curvature Metrology With High Accuracy And Resolution

Stress Impact of the Annealing Procedure of Cu-Filled TSV Packaging on the Performance of Nano-Scaled MOSFETs Evaluated by an Analytical Solution and FEA-Based Submodeling Technique

Stress Analysis of Thin Film Thermocouple Sensor Based on Finite Element Simulation

Influences of Material and Structural Factors on the Stress Conditions in Cu/low-k Chips During Cu Wire Bonding

Layout Dependence Stress Investigation in through Glass via Interposer Architecture Using a Submodeling Simulation Technique and a Factorial Design Approach

Microstructure and Residual Stress Gradient Evolution Mechanism of Electronic Copper Strip for Lead Frame