Abstract:With the fast growth in emerging technologies for mobile applications, packaging solutions are being driven by advanced Silicon (Si) nodes technology (down to 7nm), smaller form factor package designs, efficiency enhancement and lower power consumption. The flip chip chip scale package (fcCSP) has been widely adopted as the solution for mobile devices to satisfy these challenging requirements. In order to create a lower cost solution, the fcCSP uses the cost-effective combination of copper (Cu) pillar bumps, embedded trace substrate (ETS) technology, mass reflow (MR) chip attach and molded underfill (MUF) processes. Although the utilization of MR chip attach is a cost-effective process for flip chip package assembly, there is a high risk for a bump to trace short, especially for the designs with finer bump pitch and line width / line spacing (LW/LS) with an escaped trace. To reduce this risk, the laser assisted bonding (LAB) methodology is introduced to study the 7nm chip-package interaction (CPI) of an fcCSP with a 60µm bump pitch and escaped traces design in this paper. For the purpose of measuring the extremely low-k (ELK) performance in a 14x14mm fine pitch fcCSP with 7nm live die, the thunder test (two-times MR and quick temperature cycling (QTC) tests) as well as the hammer test with multi-reflow process (peak temperature at 260ºC) have been evaluated after performing LAB and MR chip attach methodologies. The results show that although both chip attach methodologies can pass the normal requirements of the thunder and hammer tests, the utilization of LAB technology can further enhance the strength of ELK and produce better yield performance. From these results, it is believed that LAB not only can guarantee assembly yield with less ELK damage risk in the examined 7nm fcCSP, but can also accommodate Si node and bump pitch reduction with a finer LW/LS substrate with escaped traces design.

An Efficient Metrology to Sense Micro-Metal Contamination in Fine-Pitch Package

Design and Validate the Chip's Power-Network in DSM

An improved method for test chip design

Dynamic Substructure Method for Prediction of Solder Joint Reliability of IC Package under Drop Test

Failure Analysis of the Contamination on the Pins of the SOT Packages

A Method for Measuring Resistance of Metal Interconnection Inside Chip

Testing Structure for Detection of Poly Stringer Defects in CMOS ICs

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

A Fully Automated Large-Scale Addressable Test Chip Design with High Reliability

A LabVIEW Based Automatic Test System for Sieving Chips

Mitigation of unintentional radiation from the package lid using PMC packaging

Optimization of approach for metal contamination reduction

Elimination of suction effect in interfacing microchip electrophoresis with inductively coupled plasma mass spectrometry using porous monolithic plugs.

Multiple Retest Systems for Screening High-Quality Chips

A Nanofluidic Sensor for Real-Time Detection of Ultratrace Contaminant Particles in IC Fabrication

7nm Chip-Package Interaction Study on a Fine Pitch Flip Chip Package with Laser Assisted Bonding and Mass Reflow Technology

Reliability Study of Fine Pitch Cu-Sn Micro-Bump Structure Electromigration Test by Finite Element Simulation

Investigation on the effect of the packaging-induced stress on the reliability of a MEMS sensor package

Machine Learning-Based Detection Method for Wafer Test Induced Defects

Design and Verification of Universal Evaluation System for Single Event Effect Sensitivity Measurement in Very-Large-scale Integrated Circuits

Trace metal contamination analysis of wafer edge and bevel by automated VPD ICP-MS: CFM: Contamination free manufacturing