Abstract:Compared with the state-of-the-art Si-based power devices, enhancement-mode Gallium Nitride (E-mode GaN) transistors have better figures of merit and exhibit great potential in enabling higher switching frequency, higher efficiency, and higher power density for power converters. The bridge-leg configuration circuit, consisting of a controlling switch and a synchronous switch, is a critical component in many power converters. However, owing to the low threshold voltage and fast switching speed, E-mode GaN devices are more prone to false turn-on phenomenon in bridge-leg configuration, leading to undesirable results, such as higher switching loss, circuit oscillation, and shoot through. In order to expand gate terminal's safe operating margin without increasing reverse conduction loss during deadtime, negative gate voltage bias for turn-off and antiparallel diode could be applied to E-mode GaN device. In this paper, with consideration of strong nonlinearities in C-V and I-V characteristics of high-voltage (650 V) E-mode GaN transistors, analytical device models are first developed. Then, we develop an analytical circuit model that combines the circuit parameters with intrinsic characteristics of the high-voltage GaN transistor and antiparallel diode. Thus, key transient waveforms with regard to the false turn-on problem can be acquired, including displacement current and false triggering voltage pulse on gate terminal. The simulated waveforms are then verified on a testing board with GaN-based bridge-leg circuit. In contrast to piece-wise switching process models and PSpice simulation, the proposed model exhibits outstanding performances. To provide design guidelines for mitigating false turn-on of GaN transistor, the impacts of different circuit parameters, along with the optimum negative gate voltage bias, are investigated based on the proposed model.

Analysis and discussion of false triggering of Vce desaturation protection circuit in a T-type neutral point clamped inverter and its solutions

Fault Analysis and Fault-Tolerant Design for Parallel Redundant Inverter Systems in Case of IGBT Short-Circuit Failures

A Self-Adaptive Blanking Circuit for IGBT Short-Circuit Protection Based on VCE Measurement

Fault Analysis on Conventional Parallel Inverter Systems

A fault-tolerant T-type three-level inverter system

A High Speed Short-Circuit Protection Circuit with Current Limitation and Soft Turn-Off for High Power IGBTs

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

Crosstalk Analysis and Suppression for a Closed-Loop Active IGBT Gate Driver

In Situ Diagnosis for IGBT Chip Failure in Multichip IGBT Modules Based on a Newly Defined Characteristic Parameter Low-Sensitive to Operation Conditions

Fast Diagnosis of Multiple Open-Circuit Faults in a T-type Inverter Based on Voltages Across Half-Bridge Switches

An Analytical Model for False Turn-On Evaluation of High-Voltage Enhancement-Mode GaN Transistor in Bridge-Leg Configuration

Detection of IGBT Degradation in NPC Inverter Based on Infrared Thermography

Analysis and Flexible DV/DT Control of an Active Clamping Topology for Series-Connected SiC MOSFETs

Analysis of IGBT Pseudodesaturation Effect Caused by Stray Parameters in DC Circuit Breaker

IGBT Drive Optocoupler with Desaturation Detection and Active Miller Clamp

An Igbt Open-Circuit Fault Diagnosis Method For Grid-Tied T-Type Three-Level Inverters

Analysis and Testing on the Switching States Transitions of Hybrid Clamped Multilevel Inverters

Analysis and Suppression of High Speed Dv/Dt Induced False Turn-on in GaN HEMT Phase-Leg Topology

The Mitigating Effects of the Threshold Voltage Shifting on the False Turn-on of GaN E-HEMTs

Analysis of Drain-Dependent Threshold Voltage and False Turn-On of Schottky-Type P-Gan Gate HEMT in Bridge-Leg Circuit

Analysis of High Di/Dt Current Pulses in Three-Level Npc Inverters Using Series Connected Igcts and Rc Snubbers