Abstract:In this study, shear rheological polishing was used to polish the Si surface of six-inch 4H-SiC wafers to improve polishing efficiency. The surface roughness of the Si surface was the main evaluation index, and the material removal rate was the secondary evaluation index. An experiment was designed using the Taguchi method to analyze the effects of four critical parameters (abrasive particle size, abrasive particle concentration, polishing speed, and polishing pressure) on the Si surface polishing of SiC wafers. By evaluating the experimental results for the signal-to-noise ratio, the weight of each factor was calculated using the analysis of variance method. The optimal combination of the process parameters was obtained. Below are the weightings for the influence of each process on the polishing result. A higher value for the percentage means that the process has a greater influence on the polishing result. The wear particle size (85.98%) had the most significant influence on the surface roughness, followed by the polishing pressure (9.45%) and abrasive concentration (3.25%). The polishing speed had the least significant effect on the surface roughness (1.32%). Polishing was conducted under optimized process conditions of a 1.5 μm abrasive particle size, 3% abrasive particle concentration, 80 r/min polishing speed, and 20 kg polishing pressure. After polishing for 60 min, the surface roughness, Ra, decreased from 114.8 to 0.9 nm, with a change rate of 99.2%. After further polishing for 60 min, an ultrasmooth surface with an Ra of 0.5 nm and MRR of 20.83 nm/min was obtained. Machining the Si surface of 4H-SiC wafers under optimal polishing conditions can effectively remove scratches on the Si surface of 4H-SiC wafers and improve the surface quality.

Study on Chemical Mechanical Polishing of Cu Single Crystal Wafer Prepared by Czochralski Method

Study on the Chemo-mechanical Polishing Quality of LiNb03 Cubic Flake

Characteristics in chemical-mechanical polishing of copper: comparison of polishing pads

Investigation for Material Removal Mechanism in Copper Chemical Mechanical Polishing with Quasi-Continuum Method

Role of Crystal Orientation on Chemical Mechanical Polishing of Single Crystal Copper

Comparison of Polishing Pad Characteristics in Copper-interconnect Chemical Mechanical Polishing of 300 Mm Wafer

Research on Surface Topography of Silicon Wafer in Chemical-mechanical Polishing

Two-Step Chemical Mechanical Polishing of 4H-SiC (0001) Wafer

Chemical Mechanical Polishing (CMP) of SiC Wafer Using Photo-Catalyst Incorporated Pad

Chemical Mechanical Polishing (CMP) of On-Axis Si-face 6H-Sic Wafer for Obtaining Atomically Flat Defect-Free Surface

Optimization of Design of Experiment for Chemical Mechanical Polishing of A 12-Inch Wafer

Copper chemical mechanical polishing using a slurry-free technique

Chemical Mechanical Polishing of 4H-SiC Wafer with UV-LED Light

Experimental Study on Shear Rheological Polishing of Si Surface of 4H-SiC Wafer

A Systematic Study of the Factors Affecting the Surface Quality of Chemically Vapor-Deposited Diamond during Chemical and Mechanical Polishing

Non-spherical abrasives with ordered mesoporous structures for chemical mechanical polishing

Study of the Humidity-Controlled CeO2 Fixed-Abrasive Chemical Mechanical Polishing of a Single Crystal Silicon Wafer

The crystallographic change in sub-surface layer of the silicon single crystal polished by chemical mechanical polishing

Chemical mechanical polishing for copper films in integrated circuit wiring layers using an advanced slurry

Research on the key technology for processing efficiency improvement of aluminum alloy mirror chemical mechanical polishing

XPS, UV–vis Spectroscopy and AFM Studies on Removal Mechanisms of Si-face SiC Wafer Chemical Mechanical Polishing (CMP)