Abstract:Abstract This paper presents an experimental study of Cu-Mo alloys prepared by powder metallurgy (PM) method. Also, improving the dispersion and wettability of Mo in the Cu matrix was aimed. Mo particles were added by 0.24, 0.48, 0.73 and 0.97% volume fraction to Cu powder. The mixture was mechanically milled by planetary ball mill at a rotational speed of 140 rpm for 24 h under hydrogen atmosphere, with milling ball size of ∼25 times the size of the metal powders. Liquid acetone was utilized as a process control agent (PCA). Paraffin wax (0.5 wt%) was used to decrease the friction with die during the compaction process. The mixture of the blended powder was compacted at ambient temperature under three different pressures (400, 600 and 800 MPa) and then sintered in a vacuum furnace at 1000 °C for 1 h by a heating rate of 5 °C min −1 . The microstructure examination showed a homogeneous dispersion of Mo particles within the Cu matrix with no evidence of new phases formation during the sintering process. Also, the relative density of samples has been increased by increasing both of Mo content and the compaction pressure. The results revealed that the compaction pressure of 600 MPa was the most suitable pressure as it gave the highest densification. Cu—0.97% volume fraction Mo alloy samples exhibited finer Mo particles with a homogenous distribution in the Cu matrix and well bonding with the Cu particles. The microhardness was increased gradually by increasing Mo wt%, while the compressive strength was decreased by increasing the Mo contents. Both the electrical and thermal conductivities were decreased gradually by the addition of Mo. While the coefficient of thermal expansion (CTE) was decreased by Mo addition.

Analysis of fabricating Mo-15 ％ Cu by pre-infiltration,warm-die-forging and rolling

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Attaining Exceptional Electrical Conductivity in Cu-Fe Composite by Powder Rolling Strategy

Fabrication and thermal expansion properties of high dense Mo/Cu composites

Highly Dense Mo/Cu Composites Fabricated by Squeeze Casting and Their Thermal Conduction Properties

Relationships between the properties and microstructure of Mo–Cu composites prepared by infiltrating copper into flame-sprayed porous Mo skeleton

Cyclic warm rolling: A path to superior properties in Mo Cu composites

Fabrication and characterization of high dense Mo/Cu composites for electronic packaging applications

Enhanced softening resistance and mechanical properties of Mo 2 C particle-reinforced Cu-matrix composites

Improving the mechanical properties and coefficient of thermal expansion of molybdenum-reinforced copper using powder metallurgy

Microstructure and thermal and electric conductivities of high dense Mo/Cu composites

Deformation Processed Cu-15 Wt Pct Cr Composite Synthesized by Hot Hydrostatic Extrusion of Mechanical Milled Powders

The thermo-physical properties of high dense Mo/Cu composites fabricated by squeeze casting technology

Effect of Cyclic Warm-Rolling Technique on Mechanical Properties of MoCu30 Thin Plates with Heterogeneous Structure

Microstructure and Mechanical Properties of High Densification Mo/Cu Composites

Microstructure and properties of Mo-50%Cu alloy by mechanical milling and pressure-assisted solid state sintering

Densification and Properties Investigation of W-Mo-Cu Composites Prepared by Large Current Electric Field Sintering with Different Technologic Parameter

Effect of Mo Nanoparticles on Microstructure and Mechanical Properties of Cu Alloys by Self-Propagating and Spark Plasma Sintering

Enhancing the physical properties of Mo-Cu composites through plasma spheroidized spherical molybdenum powder

Preparation and properties of W-Mo-Cu composite using solution combustion synthesized W Mo solid solution nanopowder

Study on the tribological properties of MoB/Cu laminated composite materials fabricated by hot-pressing process