Abstract:The metallic element Mo has almost no solid solubility in copper and can be used as a nucleation particle to refine the grain size and increase the recrystallization temperature of the alloy during solidification. It is expected to obtain copper alloys with good comprehensive properties by reasonably controlling the addition amount of Mo. However, it is difficult to prepare Cu–Mo alloys with uniform structure and there are few related literatures. In this paper, the aluminothermic reaction method, which has the advantages of simple process, low cost, and large size of the prepared alloy, was adopted, and a cluster model with the atomic ratio of Mo and Ni of 1:12 was introduced to design the alloy composition. Here, five alloys with different copper contents were prepared and followed by room temperature rolling with 40%, 60%, and 80% deformation. The results show that the as-cast Cu–Ni–Mo alloys exhibit good formability, have no macroscopic defects and present a small amount of precipitates. With the increase of alloy elements Ni and Mo, the hardness and strength of the alloys increase obviously, while the electrical conductivity decreases gradually. For the rolled alloys, a large number of lamellar deformed structures are formed, the grains are obviously refined, the precipitated phases are broken and the distribution is more uniform, thus the strength and hardness of the alloy increase significantly, the plasticity decrease significantly, while the conductivity changed little. In this study, high-strength samples were obtained, which may be a valuable exploration for the preparation of Cu–Ni–Mo alloy sheets with excellent microstructure and mechanical properties.

Cyclic warm rolling: A path to superior properties in Mo Cu composites

Effect of Cyclic Warm-Rolling Technique on Mechanical Properties of MoCu30 Thin Plates with Heterogeneous Structure

Effect of Rolling Deformation on Microstructure and Properties of Cu–Ni–Mo Alloy Prepared by Aluminothermic Reaction

Co-deformation in Cu–6 Wt.% Ag Nanocomposites

Enhanced softening resistance and mechanical properties of Mo 2 C particle-reinforced Cu-matrix composites

Effect of the rolling plastic deformation on microstructure and properties of W-Cu composite

Fabrication and thermal expansion properties of high dense Mo/Cu composites

Deformation Behavior and Microstructure Evolution of Graphene/copper Laminated Composites

Microstructure and Mechanical Properties of High Densification Mo/Cu Composites

On nanostructured molybdenum-copper composites produced by high pressure torsion

Fabrication and characterization of high dense Mo/Cu composites for electronic packaging applications

Effects on the Microstructure Evolution and Properties of Graphene/Copper Composite during Rolling Process

Mechanical deformation and properties of CuCr25 alloy

Microstructure evolution, mechanical properties and tailoring of coefficient of thermal expansion for Cu/Mo/Cu clad sheets fabricated by hot rolling

Microstructure and thermal and electric conductivities of high dense Mo/Cu composites

Microstructural evolution and mechanical property of Cu‐Cr‐Zr‐ZrB2 composites subjected to cryorolling and aging treatment

Research on Effects of Rolling-Drawing Deformation on Performance of Cu-10Ni-1Fe-1Mn Alloy

Relationships between the properties and microstructure of Mo–Cu composites prepared by infiltrating copper into flame-sprayed porous Mo skeleton

Deformation Processed Cu-15 Wt Pct Cr Composite Synthesized by Hot Hydrostatic Extrusion of Mechanical Milled Powders

Temperature dependent tensile and fracture behaviors of Mo-10 wt.% Cu composite

Microstructure and Properties of Cold Rolled Cu70Cr30 Composite