Abstract:Due to frequently occurred three-phase unbalanced loads in the ends of large number of branches in distribution networks, it is difficult to extract reflected wave of the fault point in the complex reflected and refracted waves using the traditional single-terminal traveling wave methods. Simultaneously the precision of the fault location methods based on the difference of wave velocity between zero-mode component and line-mode component of traveling waves and the one based on mutation of line-mode traveling wave are decided by the unstable zero-mode wave velocity. Therefore, a new approach is proposed by combining the above two methods to achieve higher efficiency and precision of measuring the fault distance and location. The presented method employs the correspondence between the detected zero-mode wave velocity and the fault distance to achieve the fault location algorithm which is not impacted by zero-mode wave velocity. The approach firstly detects difference of arrival time between the zero-mode traveling wave and line-mode traveling wave at the head end. And then post-injecting high voltage pulses into three phases simultaneously and detecting the arrival time of the first line-mode traveling wave head at the head end of the transmission line. Following, it employs the stable line-mode wave velocity to execute the measurement of the fault distance. Finally, PSCAD-based simulation shows that the absolute errors of this algorithm are less than 100 m in all cases, without influence from the fault location, grounding resistance and fault initial phase angle.

Applicable Range Analysis of Optimized Single-Terminal Fault Location Algorithm

Optimizing Solution of Fault Location Using Single Terminal Quantities

Optimizing solution of fault location

Fault Location Algorithm for HV Transmission Lines Immune to Saturation of Current Transformers

Location of Faulty Section and Faults in Hybrid Multi-Terminal Lines Based on Traveling Wave Methods

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

A single-terminal fault location algorithm in distribution network for eliminating the effect of the velocity of zero-mode traveling wave

Eliminating the Dependence of GPS or Communication Latency Estimation in Traveling Wave Based Double-Terminal Fault Location

Distributed Traveling-Wave-Based Fault-Location Algorithm Embedded in Multiterminal Transmission Lines

Novel location algorithm for single-line-to-ground faults in transmission line with distributed parameters

Novel and Comprehensive Countermeasures for Single Terminal Fault Location of Transmission Lines

New Fault Location Algorithm for Double Transmission Lines on a Same Tower

Fault Location on Multi-Branch Network Using Traveling Wave and Graph Theory

An Accurate Unsynchronized Fault Location Method on Practically Transposed Transmission Lines with Closed-Form Solutions

Travelling Waves Based Fault Location Method for Overhead-Cable Hybrid Multi-Terminal Transmission Line

Fault Model and Travelling Wave Matching Based Single Terminal Fault Location Algorithm for T-Connection Transmission Line: A Yunnan Power Grid Study

Study of fault location for parallel transmissions lines using one terminal current traveling waves

A Single-Terminal Fault Location Method for Transmission Lines Integrated by Inverter-Type Source

Improved Fault Location Through Analysis of System Parameters During Autoreclose Operations on Transmission Lines

A novel fault location method for hybrid lines based on traveling wave

An Accurate Fault Location Algorithm for Parallel Transmission Lines Using One-Terminal Data