Abstract:Non-uniform corrosion of steel reinforcing bars is the main cause of structural failure in civil engineering. However, the accurate measurement of the critically corroded cross-sectional area, or the pit shape, is difficult owing to conventional limitations on detection. To accurately represent the corrosion morphology and better understand the corrosion effects on the tensile responses of deformed steel bars, a three-dimensional model of a corroded steel bar was reconstructed using a three-dimensional (3D) laser scanner. Based on the elicited 3D profiles, the corrosion factors-including the corrosion uniformity-the average, and maximum cross-sectional areas and their relationships, were identified in this study. The statistical analyses indicated that the number of corroded pits and their depths increased when the corrosion rate increased, and that decreases of the critical cross-sectional areas were linearly related to the average mass loss. Axial tensile tests of corroded steel bars were also carried out. The tensile test results showed that both the yield and the ultimate loads linearly decreased with increases in corrosion loss. Corresponding decreases in ductility were also observed. Compared with the degradation in the strength, the non-uniform corrosion had a considerable effect on the loss of ductility. The relationships between the mechanical parameters and the corrosion factors were established on the basis of the experimental results, and compared with the available prediction models. It was found that fractures originated at the locations of the critically corroded pit, and brittle fracture gradually occurred at the weakest location of the corroded steel bar, evidenced by concomitant increases in corrosion loss. Numerical simulations were carried out to clarify the critical section, the effect of pit corrosion on the concentration of stress, and the tensile response of the corroded steel bar, based on the 3D model reconstructed using scanning.

Fractal characterization of corroded surface profile in reinforcing steel bars

Fractal Based Characterization of Nonuniform Corroded Surface Profile in Steel Bars

Fractal Characterization of Non-Uniform Corrosion of Steel Bars in Concrete Beams after Accelerated Depassivation and Seven-Year Natural Corrosion.

Ultra-low Cycle Fatigue Properties and Fracture Mechanism of Corroded Structural Steel

Multifractal Analysis of Reinforcing Steel Bars with Nonuniform Corrosion Degree

Comparing Monofractal And Multifractal Analysis Of Corrosion Damage Evolution In Reinforcing Bars

Evaluation of corrosion morphology on mechanical properties of reinforcing steel bars using numerical simulation and simplified analytical model

Fractal Characteristics of Corrosion-Induced Cracks in Reinforced Concrete.

Influence of Coupled Chemo-Mechanical Process on Corrosion Characteristics in Reinforcing Bars

Measurement pitting morphology characteristic of corroded steel surface and fractal reconstruction model

Bond Strength Evaluation of Corroded Steel Bars Via the Surface Crack Width Induced by Reinforcement Corrosion

Formation Mechanism of Corroded Surface Profile in Reinforcing Bars under Coupled Chemomechanical Attacks

Modelling the corrosion mechanism of steel bars in chloride-contaminated concrete with transverse cracks

Rust Distribution And Corrosion-Induced Cracking Patterns Of Corner Located Rebar In Concrete Cover

Evaluation of Corrosion Characteristics and Corrosion Effects on the Mechanical Properties of Reinforcing Steel Bars Based on Three-Dimensional Scanning

Prediction of Corrosion-Induced Crack Width of Corroded Reinforced Concrete Structures

Non-uniform distribution of rust layer around steel bar in concrete

Mechanical Performance of Corroded Steel Bars in Concrete

Mill Scale and Corrosion Layer at Concrete Surface Cracking

Cover Cracking Model in Reinforced Concrete Structures Subject to Rebar Corrosion

Non-Uniform Distribution of A Corrosion Layer at A Steel/Concrete Interface Described by A Gaussian Model