Abstract:Fracture toughness of base metal, weld seam and heat-affected-zone (HAZ) in X100 high-strength pipeline steel welded joints was investigated by three-point crack tip opening displacement (CTOD) test. Microstructure and inclusion near fracture zones were observed by means of SEM and TEM. The results indicated that fracture toughness of X100 high-strength pipeline steel welded joints was greatly influenced by test temperature. At the same temperature, the numerical values of apparent crack initiation delta(0.05), conditional crack initiation delta(0.2) and delta(0.2BL) of base metal are higher than that of weld seam and HAZ, and low temperature fracture toughness of base metal is better than those of weld seam and HAZ. With temperature decreasing, the fracture toughness of base metal, weld seam and HAZ decreased. The microstructure of near fracture zones of base metal specimen was composed of granular bainite (GB), a small quasi polygonal ferrite (QF) and lath bainite ferrite (BF), and the fine and equally dispersed M-A structure distributed on the grain boundary. The microstructure of near fracture zones of weld seam specimen was composed of acicular ferrite (AF), and the form of M-A constituents shows diversity, sharp-angled clearly. The microstructure of near fracture zones of coarse grain HAZ was composed of GB and parallel LBF, and the square, wedged and bar M-A constituents distributed on the interior of grain, grain boundary and lath boundary. The poor fracture toughness of weld seam and HAZ specimen results from large size and cusp type M-A structure. While the higher distribution of inclusion in weld seam makes fracture toughness worse.

Crack Tip Opening Displacement of X100 Sawl Pipe

Fracture Toughness Investigation of X100 Longitudinal Submerged Arc Welded Pipe Via Crack Tip Opening Displacement Test

Experimental Research on Fracture Toughness of High Grade Line Pipe

FRACTURE TOUGHNESS OF WELDED JOINTS OF X100HIGH-STRENGTH PIPELINE STEEL

Experiment on the Fracture Toughness of Weld Joint of X70 Pipeline Steel

FRACTURE TOUGHNESS OF X70 PIPELINE STEEL AT DIFFERENT TEMPERATURES

The fracture resistance and crack propagation path of L415/N08825 bimetallic composite pipe welded joint

Study on Fracture of Non-Through Crack Bodies of X60 Pipeline Steel

Ductile to Brittle Fracture Transition of a Pipe Line Steel X70

Cracking Reasons of X70 Steel Submerged Arc Weld Pipe during Guide-Bend Test

Study on Local Brittle Zone Phenomena of Intercritically Reheated Coarse-Grained Heat-Affected Zone in Pipeline Steels

Fracture analysis of X80 welded joints with variable wall thickness and misalignment

Initiation of Stress Corrosion Cracks in X80 and X100 Pipe Steels in Near-Neutral Ph Environment

Types and Cause of Cold Bending Crack Defects of Welded Pipe

Experimental study on fracture toughness of high-strength structural steel and its butt weld

The Fracture Toughness of Butt Weld at Low Temperature of 960 MPa High-strength Steel

3- Point Bending Test of X70 Pipeling Steel with V Notch along Different Orientation

Analysis on Cracking of a Pipeline Steel Pipe during Hydraulic Burst Test

The 3-Point Bending Fracture Test of X70 Plpeline Steel Samples with V Notch

Improving the Weld Heat-Affected-Zone (HAZ) Toughness of High-Strength Thick-Walled Line Pipes

Micromechanism of the transition of fibrous cracking to cleavage of C-Mn base and weld steel