Abstract:This research was aimed at determining the effect of optical variables for a single integrating sphere system, coupled with the inverse adding-doubling method, on estimating the reduced scattering coefficient (mu s') of turbid media. Integrating sphere measurements were performed on a total of 36 liquid samples and two solid samples. The results demonstrated that the system had good accuracy, with average errors for estimating absorption coefficient mu(a) (pure absorption) and mu s' (pure scattering) of liquid samples being 15.0% and 4.7% over 550-900 nm, compared with the collimated transmittance and empirical equation, respectively. The system also had good reproducibility for mu(a) and mu s', with the coefficients of variation lower than 4%. Sensitivity analysis revealed that the detectable values of mu(a) and mu s' were around 0.02 cm(-1)- and 4.5 cm(-1). Entrance and detector port diameters, standard reflectivity and anisotropy factor had a negligible effect on estimating mu s' (<2.2%). However, refractive indices of sample and cuvette, sphere wall reflectivity, beam diameter and its position, and specular reflectance had a relatively large effect on the estimation of mu s' (2.8%-35.3%). Hence these variables should be carefully chosen or accurately measured before optical property measurements are carried out. Application examples of the mu s' estimation for apple skin and flesh further validated the system performance, indicating that appropriate selection of optical variables could improve the estimation of mu s'. Published by Elsevier Ltd on behalf of IAgrE.

Analysis of the Measured Method for Scattering Properties of High-Reflection Coating

Loss Measurement for SCF Materials

Spectrophotometer for Measuring Spectral Transmittance and Reflectance of Large Aperture Optical Element

Numerical Analysis of Thermal Response of Mid-Infrared High Reflectance Coating under Different Laser Irradiation Angles

Measurement of Absolute Phase Shift on Reflection of Thin Films Using White-Light Spectral Interferometry

Roughness Characterization of Well-Polished Surfaces by Measurements of Light Scattering Distribution

Scanning Interferometric Method for Measuring Group Delay of Dispersive Mirrors

Fabrication and measurement of low polarization anti-reflection coating at 248 nm

A Spectroscopic Transmittance Analytical Modeling for Field-Widened Michelson Interferometer Employed by High Spectral Resolution Lidars

Error impact analysis and experimental research for absolute testing of spherical surfaces

Measurement of the Group Refractive Index of Bulk Material Using White-Light Spectral Interferometry

The Research of a Method to Obtain the Optical Parameters of Semiconductor Films

Modified Brillouin Intensity Measurement Method for a General Brillouin Scattering System

Study on Method for Measuring Coating Emissivity by Applying Active Irradiation Based on Infrared Thermal Imager

Measuring Spectral Reflectance and Transmittance of Heavy Caliber Optical Thin-Film

Influence of Coating Spray on Surface Measurement Using 3D Optical Scanning Systems

Determination and Calculation for the Heat Reflectance of Solar Reflective Coatings

Defect Analysis of UV High-Reflective Coatings Used in the High Power Laser System

Effects of Optical Variables in a Single Integrating Sphere System on Estimation of Scattering Properties of Turbid Media

Modeling and Analysis of Reflectance Integrating Sphere

Measurement of Surface Scattering Characteristics of Black Materials in Thomson Scattering System