Effects of Optical Variables in a Single Integrating Sphere System on Estimation of Scattering Properties of Turbid Media

Dong Hu,Renfu Lu,Yuping Huang,Yibin Ying,Xiaping Fu
DOI: https://doi.org/10.1016/j.biosystemseng.2020.03.012
IF: 5.002
2020-01-01
Biosystems Engineering
Abstract:This research was aimed at determining the effect of optical variables for a single integrating sphere system, coupled with the inverse adding-doubling method, on estimating the reduced scattering coefficient (mu s') of turbid media. Integrating sphere measurements were performed on a total of 36 liquid samples and two solid samples. The results demonstrated that the system had good accuracy, with average errors for estimating absorption coefficient mu(a) (pure absorption) and mu s' (pure scattering) of liquid samples being 15.0% and 4.7% over 550-900 nm, compared with the collimated transmittance and empirical equation, respectively. The system also had good reproducibility for mu(a) and mu s', with the coefficients of variation lower than 4%. Sensitivity analysis revealed that the detectable values of mu(a) and mu s' were around 0.02 cm(-1)- and 4.5 cm(-1). Entrance and detector port diameters, standard reflectivity and anisotropy factor had a negligible effect on estimating mu s' (<2.2%). However, refractive indices of sample and cuvette, sphere wall reflectivity, beam diameter and its position, and specular reflectance had a relatively large effect on the estimation of mu s' (2.8%-35.3%). Hence these variables should be carefully chosen or accurately measured before optical property measurements are carried out. Application examples of the mu s' estimation for apple skin and flesh further validated the system performance, indicating that appropriate selection of optical variables could improve the estimation of mu s'. Published by Elsevier Ltd on behalf of IAgrE.
What problem does this paper attempt to address?