Abstract:The performance and reliability of Ultra-Low-Power (ULP) computing platforms are adversely affected by environmental temperature and process variations. Mitigating the effect of these phenomena becomes crucial when these devices operate near-threshold, due to the magnification of process variations and to the strong temperature inversion effect that affects advanced technology nodes in low-voltage corners, which causes huge overhead due to margining for timing closure. Supporting an extended range of reverse and forward body-bias, UTBB FD-SOI technology provides a powerful knob to compensate for such variations. In this work we propose a methodology to maximize energy efficiency at run-time exploiting body biasing on a ULP platform operating near-threshold. The proposed method relies on on-line performance measurements by means of Process Monitoring Blocks (PMBs) coupled with an on-chip low-power body bias generator. We correlate the measurement performed by the PMBs to the maximum achievable frequency of the system, deriving a predictive model able to estimate it with an error of 9.7% at 0.7V. To minimize the effect of process variations we propose a calibration procedure that allows to use a PMB model affected by only the temperature-induced error, which reduces the frequency estimation error by 2.4x (from 9.7% to 4%). We finally propose a controller architecture relying on the derived models to automatically regulate at run-time the body bias voltage. We demonstrate that adjusting the body bias voltage against environmental temperature variations leads up to 2X reduction in the leakage power and a 15% improvement on the global energy consumption when the system operates at 0.7V and 170MHz

A Novel Adaptive Reverse Body Bias Technique to Minimize Standby Leakage Power and Compensate Process and Temperature Variations

Variation-aware gate sizing and clustering for post-silicon optimized circuits.

A Novel Bias Circuit Design in Low Power Lcd Driver

Design Time Body Bias Selection for Parametric Yield Improvement.

A method to reduce process-related sensitivity in sub-threshold ICs and its circuit implementation

Adaptive Power Management for Nanoscale SoC Design

Performance-Aware Predictive-Model-Based On-Chip Body-Bias Regulation Strategy for an ULP Multi-Core Cluster in 28nm UTBB FD-SOI

Leakage Power and Circuit Aging Cooptimization by Gate Replacement Techniques

Energy-aware Supply and Body Biasing Voltage Scheduling Algorithm

Study on leakage power estimation and reduction methodology of CMOS circuit

SRAM Standby Leakage Decoupling Analysis for Different Leakage Reduction Techniques

Gate Replacement Techniques For Simultaneous Leakage And Aging Optimization

Temperature-Aware NBTI Modeling and the Impact of Standby Leakage Reduction Techniques on Circuit Performance Degradation

On the efficacy of input Vector Control to mitigate NBTI effects and leakage power

Exploring Variability and Performance in a Sub-200-mV Processor

Variation-aware Supply Voltage Assignment for Minimizing Circuit Degradation and Leakage.

Low-Power High-Yield Sram Design With Vss Adaptive Boosting And Bl Capacitance Variation Sensing

Minimizing Leakage Power In Aging-Bounded High-Level Synthesis With Design Time Multi-V-Th Assignment

Nbti-Aware Dual V-Th Assignment for Leakage Reduction and Lifetime Assurance

NBTI and Power Reduction Using a Workload-Aware Supply Voltage Assignment Approach

Negative Design Margin Realization through Deep Path Activity Detection Combined with Dynamic Voltage Scaling in a 55 nm Near-Threshold 32-Bit Microcontroller