Abstract:Stable nickel (Ni) isotope has shown great potential for investigating planetary accretion processes, mantle-crust magmatism, and paleo-marine evolution. The development of an economical and time-efficient separation method for Ni isotope analysis holds significant value within the realm of Ni isotope research. Previous purification methods for Ni isotope analysis have typically relied on either multi-column procedures or the utilization of significant quantities of organic reagents, such as acetic acid, acetone, dimethylglyoxime. In this study, a novel two-column chromatographic separation procedure was presented for the determining Ni isotope compositions in geological materials. The cation resin (AG50W-X8) was utilized in conjunction with diluted HCl and HF to effectively remove a substantial portion of matrix elements. Subsequently, trace amounts (100–200 μL) of Ni-spec resin were used for further purification of Ni. This relatively simple purification scheme for Ni isotope analysis effectively reduces the introduction of organic regents and the amount of Ni-spec resin compared to previous methods relied on multiple-column separation and organic reagent extraction. Ni isotopic compositions were analyzed using multi-collector inductively coupled plasma mass spectrometry (MC-ICP-MS). The instrumental mass fractionation of Ni isotopic ratios was corrected using the double spike (DS) combined with the sample-standard-bracketing method (SSB). The Ni isotope compositions (δ 60 Ni) of in-house standards (SCP and CUG) were -0.06 ± 0.05‰ (2 SD, n=104) and 0.36 ± 0.06‰ (2 SD, n=97), respectively. Furthermore, the measured δ 60 Ni values of various geological reference materials (BCR-2, BHVO-2, BIR-1, DTS-1, DTS-2b, SDO-1, GSP-2, W-2a from the USGS, JB-1b from the GSJ, GSR-2, GSR-3, GSR-4, GSR-5, GSR-10 from the NRCGA) were consistent with previous studies within measurement error. Additionally, the δ 60 Ni values of AGV-1 from the USGS, as well as GSR-10, GSR-12, GSR-15, GSR-17, GSR-18, GSR-19 from the NRCGA are reported here for the first time. Based on repeated measurements of pure solutions and reference materials, the long-term reproducibility of δ 60 Ni values was better than ± 0.06‰ (2 SD). Consequently, our study presents a relatively straightforward purification method of Ni for its isotopic analysis using only trace amounts of organic regents and Ni-spec resin.

Determination of trace nickel in Bi-based superconductor powder by inductively coupled plasma atomic emission spectroscopy after separation with anion exchange resin and extraction with methylbenzene

Enrichment of trace iron with activated carbon in Bi-based superconductor powder and determination by inductively coupled plasma atomic emission spectroscopy

Correction of Spectral Interferences with Mutual Interference Coefficient Matrix for Determination of Impurities in Bi-Based Superconductor Powder by Inductively Coupled Plasma Emission Spectrometry

Determination of trace elements in high purity nickel by high resolution inductively coupled plasma mass spectrometry

Determination of As, Pb, Sn, Sb and Bi in High Temperature Iron and Nickel-Based Alloy by Graphite Furnace Atomic Absorption Spectrometry Combined with Liquid-Liquid Extraction

Determination of Trace Phosphorus in Cobalt-Niobium-zirconium Alloy by Inductively Coupled Plasma Atomic Emission Spectrometry

Determination of Bismuth Based Superconductor by ICP-AES

In-situ Separation of the Matrix for the Direct Determination of Traces of Chromium, Cobalt, and Nickel in Titanium Dioxide Powder by Electrothermal Atomic-Absorption Spectrometry with Slurry Sampling

Determination of Ni,Al,P,Mg and Ca in Nickel Ores by Inductively Coupled Plasma-Atomic Emission Spectrometry

Determination of Trace Amounts of Nickel in Cobalt-Chromium-Molybdenum Alloys by Icp-Aes after Liquid-Liquid Extraction

ICP-OES Determination of trace Ga,In,Bi,Sn and Pb preconcentrated by macroporous poly(vinylethylenediamine) chelating resin

Determination of Impurities in High Pure Copper by Electrolytic Separation-Inductively Coupled Plasma Mass Spectrometry

Determination of Bi in High-Purity Lead and Cadmium Metals by Flame Atomic Absorption Spectrometry after On-Line Matrix Separation

Quantification of Trace Amounts of Impurities in High Purity Cobalt by High Resolution Inductively Coupled Plasma Mass Spectrometry

Determination of Elemental Impurities in Iron-Nickel-Based Superalloys by Glow Discharge Mass Spectrometry

Determination of Impurity Elements in High-Purity Niobium Pentoxide by ICP-AES

Two-step chromatographic purification method of Ni for its isotopic analysis by MC-ICP-MS

Volatilization of Cr, Co, Mn and Ni as their pyrrolidinecarbodithioate chelates from electrothermal vaporizer for sample introduction in inductively coupled plasma optical emission spectrometry.

Determination of Trace Amounts of Lead, Arsenic, Nickel and Cobalt in High-Purity Iron Oxide Pigment by Inductively Coupled Plasma Atomic Emission Spectrometry after Iron Matrix Removal with Extractant-Contained Resin.

Determination of Trace Metal Impurities in High Pure Tin Oxide Electrode Material by Inductively Coupled Plasma Mass Spectrometry

Systematic Study for Determining As, Pb, Cd, and Se in Steel and Nickel Alloy Samples by GF AAS: Circumventing Matrix Interference with Extraction Based on Micellar Separation