Abstract:There is great economic incentive in developing efficient catalysts to produce hydrogen or syngas by catalytic partial oxidation of methane (CPOM) since this is a much less energy-intensive reaction than the highly endothermic methane steam reforming reaction, which is the prominent reaction in industry. Herein, we report the catalytic behavior of nickel-based catalysts supported on different oxide substrates (Al2O3, CeO2, La2O3, MgO, and ZrO2) synthesized via wet impregnation and solid-state reaction. Furthermore, the impact of Rh doping was investigated. The catalysts have been characterized by X-ray diffraction, N2 adsorptiondesorption at -196°C, temperature-programmed reduction, X-ray photoelectron spectroscopy, O2-pulse chemisorption, transmission electron microscopy, and Raman spectroscopy. Supported Ni catalysts were found to be active for CPOM but can suffer from fast deactivation caused by the formation of carbon deposits as well as via the sintering of Ni nanoparticles (NPs). It has been found that the presence of Rh favors nickel reduction, which leads to an increase in the methane conversion and yield. For both synthesis methods, the catalysts supported on alumina and ceria show the best performance. This could be explained by the higher surface area of the Ni NPs on the alumina surface and presence of oxygen vacancies in the CeO2 lattice, which favor the proportion of oxygen adsorbed on defect sites. The catalysts supported on MgO suffer quick deactivation due to formation of a NiO/MgO solid solution, which is not reducible under the reaction conditions. The low level of carbon formation over the catalysts supported on La2O3 is ascribed to the very high dispersion of the nickel NPs and to the formation of lanthanum oxycarbonate, through which carbon deposits are gasified. The catalytic behavior for catalysts with ZrO2 as support depends on the synthesis method; however, in both cases, the catalysts undergo deactivation by carbon deposits.

Experimental Study and Modeling Analysis of Catalytic Partial Oxidation of Methane with Addition of Co2 and H2o Using A Rh-Coated Foam Monolith Reactor

Catalyst Deactivation of Rh-Coated Foam Monolith for Catalytic Partial Oxidation of Methane

Catalytic partial oxidation of methane over rhodium coated foam monolith

Analysis of catalytic partial oxidation of methane on rhodium-coated foam monolith using CFD with detailed chemistry

Stability of Rh-coated Foam Monolith for Catalytic Partial Oxidation of Methane

Simulation of Partial Oxidation of Methane on the Rhodium Coated Foam Monolith Based on the Elementary Kinetics

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

Studies on the Performance and Structure of Supported Catalysts for the Partial Oxidation of Methane to Syngas

Study on Methane Conversion over WOx/Co-Fe-Mo-O Catalysts

The Experiment and Modeling of Supported Wacker-type Catalyst for CO Oxidation at High Relative Humidity

Oxidative Coupling of Methane over Pt/Al2O3 at High Temperature: Multiscale Modeling of the Catalytic Monolith

High-Pressure oxidative coupling of methane on alkali metal catalyst – Microkinetic analysis and operando thermal visualization

Expanded Reactor Engineering Calculations for the Oxidative Coupling of Methane

Study of Partial Oxidation and CO2 Reforming of Methane on Co Based Catalysts

Reforming of CH4 with CO2 over Rh/H-Beta: Effect of rhodium dispersion on the catalytic activity and coke resistance

Catalytic HDO of pyrolysis oil in supercritical ethanol with CoMoP and CoMoW catalysts supported on different carbon materials using formic acid as in-situ hydrogen sources

Partial oxidation of methane coupled with CRM and SRM in a tubular membrane reactor: a CFD simulation study

Promoted Ni Catalyst Over Titania-Zirconia Support for Partial Oxidation of Methane: Simple and Practical Catalysts

Partial Oxidation of Methane to Syngas over Cr2o3 Catalysts

Formation of H2O in the CH4-CO2 dry reforming process and its activation to this reaction over Ni-Fe/MC12A7 catalysts

Partial Oxidation of Methane to Syngas Over Nickel-Based Catalysts: Influence of Support Type, Addition of Rhodium, and Preparation Method