Stability of Rh-coated Foam Monolith for Catalytic Partial Oxidation of Methane

Shi DING,Yin-hong CHENG,Chang-ning WU,Yong JIN,Yi CHENG
DOI: https://doi.org/10.3321/j.issn:1009-606X.2009.02.030
2009-01-01
Abstract:The stability of Rh-coated foam monolith with different pore sizes for catalytic partial oxidation of methane was investigated. The results showed that 0.3%(ω) Rh coated foam with 3 mm in length and 0.32 mm in pore size had similar initial catalytic performances with the foam at 10 mm in length and 0.576 mm in pore size, but its deactivation rate was only 1/5 of the latter. The CFD modeling coupled with detailed elementary kinetics was successfully established and applied to predict the species concentration and surface temperature profiles within the two catalysts above. The foam with a smaller pore size, which had a higher catalytic surface area per unit volume, increased the rates of exothermic oxidation reaction and endothermic reforming reaction by 1.1 and 3.7 times, respectively. As a consequence, more steam reforming reaction occurred and its hot-spot temperature was 171°C lower than the foam with a larger pore size. The hot-spot temperature of the foam with 0.576 mm in pore size was decreased by 235°C after increasing its catalytic surface area per unit volume by 8 times.
What problem does this paper attempt to address?