Abstract:A flat-field holographic concave grating can be the only optical element in a spectrometer. If the mutually compensating roles of the concave grating and the spectrometer are taken into account, the difficulty of fabricating concave grating can be reduced. When the holographic method is used to make concave gratings, it is very difficult to fix precisely the spatial distances between the two recording points and the vertex of concave gratings. In like manner, it is also difficult to fix precisely the location of the entrance slit or the CCD in using concave gratings in spectrometers. In other words, during the fabrication stage and the end-use stage of concave gratings, there are inevitable errors between the practical system structure parameters and the theoretical ones. The authors name them fabrication structure errors and end-use structure errors, respectively. Numerical simulation indicates that these two classes of errors will seriously deteriorate the spectral image quality. At present, there are few references describing the elimination of the fabrication and end-use errors of concave gratings. In this paper, a concave grating used in a compact chromatograph is analyzed as an example. By performing numerical simulations that take both fabrication structure parameters and end-use structure parameters into consideration, we found that in a large neighborhood around the design point, the two sets of parameters can mutually compensate. This means that even both sets are away from the optimized design points, as long as proper compensations are made, the spectral image quality of the spectrometer can be as good as designed. In other words, on the one hand, for a specific concave grating that has been made with some fabrication structure errors, we can move the CCD to find an appropriate location where the spectral image quality is as good as designed; On the other hand, for a decided end-use system which has some end-use structure errors, we can adjust the fabrication structure to make concave gratings that will generate good spectral images in this end-use system. The experiment results show that this method is an effective way to adjust the optical system for grating fabrication. The authors also give experimental results that agree with simulation results. Such compensation can reduce both the alignment difficulty and the required precision of fabrication structure parameters of concave gratings. It could also give theoretical guidance to the design and assembly of spectrometers.

Angle measurement error and compensation for decentration rotation of circular gratings

Analysis and Compensation of Installation Errors for Circular Grating Angle Sensors

Error Compensation and Parameter Identification of Circular Grating Angle Sensors

Error Compensation for Eccentric Motions of Circular Gratings

One-Dimensional Angle Measurement Error Calibration Technique for Fiber Optic Gyroscope

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Eccentricity Parameter Identification of Angle Sensors for Articulated Arm CMMs

Error Compensation in One-Point Inclined-Axis Nanogrinding Mode for Small Aspheric Mould

A New Optical Angle Measurement and Compensation

Investigation of Heterodyne Interferometer Technique for Dynamic Angle Measurement: Error Analysis and Performance Evaluation

S5-5 research on the moiré fringes formed by circular grating and linear grating

The accurate measurement of angle based on Talbot effect of Ronchi grating

Research on the Moiré fringes formed by circular and linear grating

S4-4 angle measurement method based on the duel gratings combination

Circular grating angle-division measuring equipment based on closed loop controlling system

Error Testing and Compensation of an Inductosyn-Based Angular Measurement System

An Ultra-Precision Error Estimation for a Multi-Axes Grating Encoder Using Quadrant Photodetectors

Numerical Simulation and Experimental Demonstration of Error Compensation Between Recording Structure and Use Structure of Flat-Field Holographic Concave Gratings

Measurement accuracy of articulated arm CMMs with circular grating eccentricity errors

Rotation error modeling and compensation of spindle based on Clarke transformation in straightness error measurement of regular hexagon section shaft

Phase Error Compensation and Accuracy Analysis for Phase Measurement Profilometry