Abstract:The influence of M1 (lower level Cu) line width on stress-induced voiding (SIV) behavior of copper dual damascene interconnects was investigated by stress migration test at 200 degrees C and finite element analysis (FEA). M I line width under study ranged from 200 run to 1000 nm, whereas the M2 line width was fixed to be 3 mu m. The normalized change in resistance indicated that the via-line structures with larger M1 line width were more susceptible to SIV Failure analysis utilizing focus ion beam (FIB) showed that voids were fon-ned in the via bottom region for samples with M I line width less than 280 nm. However, voids were found at the Si3N4/M1 Cu interface near the via bottom if M I line width is larger than 280 nm.To further understand the underlying physics of SIV, three dimensional finite element models were built to Simulate the hydrostatic stress distribution in the via-line structures. It was found that the stress gradient in the length direction, grad sigma(1), was not sensitive to M1 line width, however, the stress gradient in the line width direction, grad sigma(w), was found to increase with M I line widths. It is thus proposed that in addition to the active diffusion volume, it is the grad sigma(w) that further favors the migration of voids (or vacancies) along the Si3N4/M1 Cu interface and subsequent accumulation of the voids near the via bottom leading to a much higher resistance change at larger M1 widths. (c) 2005 Elsevier B.V. All rights reserved.

A Stress Relief Method for Copper Filled Through Silicon Via with Parylene on Sidewall

Wetting Process of Copper Filling in Through Silicon Vias

Effect of leveler on microstructure and stress of electroplated copper for TSV application

Pretreatment to Assure the Copper Filling in Through-Silicon Vias

Study on the behaviors of Cu filling in special through-silicon-vias by the simulation of electric field distribution

Influence of Electroplating Current Density on Through Silicon Via Filling

Multiphysics Characterization of Polymer‐filled Through‐silicon Vias (pf‐tsvs) for Three‐dimensional Integration

Study of internal stress on electroplating copper used in through silicon via filling

Effects Of Via Pitch On Silicon Stress In Tsv Interposer

ANALYSIS OF THERMAL STRESS IN THROUGH SILICON VIA OF INTERPOSER

Influence of Copper Pumping on Integrity and Stress of Through-Silicon Vias

Interfacial Stress in Through Silicon Vias

A New Method to Fabricate Sidewall Insulation of TSV Using a Parylene Protection Layer

Reliability study of through-silicon via (TSV) copper filled interconnects

On the origins of near-surface stresses in silicon around Cu-filled and CNT-filled through silicon vias

Reliable Design of Electroplated Copper Through Silicon Vias

The Effect of Line Width on Stress-Induced Voiding in Cu Dual Damascene Interconnects

Thermal Stresses of Tsvs with Silicon Post Conductors and Polymer Insulators

Fabrication, electrical characterization and reliability study of partially electroplated tapered copper through-silicon vias

Finite Element Analysis of the Thermal-Hygroscopic Stress of the Through Silicon Vias(TSV) Interconnect Structure