Aliaksei Sukhotski,Dzmitry Siarheevich Bychanok,Henry Volunets,Aexander Gilev,Siarhei Huseu,Evgeny Gurnevich,Sergey A Maksimenko,Vladimir Petrakovski,Artur Pakrouski,Igor Pobol,Alexandr Burin,Alexey Pobol,Vitaly Zalessky,Maria Gusarova,Mikhail Lalayan,Sergey M. Polozov,Yegor Tamashevich,Dmitry Cherkunov,Alena Kotova,Yuri Bespalov,Dmitry Nikiforov,Andrey Butenko,Evgeny Syresin,Grigory Trubnikov

Abstract:A niobium prototype and two test unjacketed 325 MHz coaxial half-wave cavities with beta=0.21 were designed, fabricated, and tested at low RF fields. Electromagnetic properties were investigated using a vector network analyzer in the frequency domain and an RF generator, directional couplers, and power detectors in the time domain (both continuous wave and pulse mode). We analyzed and compared the response of the low-beta cavity in both normal and superconducting states. We studied the relationship between the resonator parameters and coupling devices to optimize the design of the RF power coupler and field probe antenna, aiming to achieve accurate cavity characterization. We proposed a tunable power coupler design that allows for varying the coupling coefficient when operating in a vacuum at liquid helium temperature. The typical responses of the cavity in case of under-, critical-, and over-coupling conditions obtained within a single cool-down are presented and analyzed. We introduced a simplified method based on decay measurements with cavity port switching for effective cavity characterization at low RF amplitudes. This method aligns well with standard Q-factor measurement protocols and can expedite experimental investigations with small RF signals. The Q 0 (E acc ) curve for half-wave resonators at ultra-low amplitudes is analyzed and discussed. Experiments with coaxial half-wave cavities showed an almost constant Q 0 at RF fields ranging from 10 -4 MV/m to 10 -1 MV/m. Additionally, a significant increase in the quality factor was observed after 120 ○ C baking. The presented results are discussed in the context of potential low-field applications of superconductive cavities.

Design of a 450 MHz Β = 0.2 Single Spoke Cavity at PKU

Design of a ββ = 0.45, f = 350 MHz Spoke Cavity

Design Of A Beta=0.45, F=350 Mhz Spoke Cavity

Design of a 325MHz Beta=0.12 superconducting single spoke cavity for China-ADS

Study On High Order Modes Of A Beta=0.45, F=350mhz Spoke Cavity

R&d of pku single spoke cavity

A Preliminary Quadrupole Asymmetry Study of a Β=0.12 Superconducting Single Spoke Cavity

Design study on very low Beta spoke cavity for China-ADS

Mechanical design and analysis for a low beta squeezed half-wave resonator

Development of a 166.6 MHz β = 1 higher-order-mode-damped superconducting cavity

Electromagnetic Design and Optimization of a Superconducting Quarter Wave Resonator

Design study of a beta=0.09 high current superconducting half wave resonator

Mechanical Analysis of a Β=0.09 162.5mhz Taper HWR Cavity

RF Design of 650-Mhz 2-Cell Cavity for CEPC

Geometry Dependent Multipacting of a Superconducting Quarter-Wave Resonator at PKU

Mechanical Analysis of Lowβ162.5 MHz Taper HWR Cavity

Electromagnetic properties of superconductive low-beta 325 MHz half-wave resonators at low RF field

Electromagnetic Design and Beam Dynamics Simulation of a New Superconducting Accelerating Structure for Extremely Low Β Protons

Simulation Study on 104 MHz Radio Frequency Quadrupole Accelerator

Design and primary test of full scale cavity of cyciae-100

Design and Measurements of SFRFQ Cavity