Abstract:Quartz is a widely used material in the field of microelectromechanical systems (MEMS) for fabricating devices such as substrates, probes, and lenses; it is also indispensable as a resonator or oscillator for frequency control in communication and network technologies. However, its development is limited because it is difficult to fabricate an ideal profile for implementation in complex structures. In practice, wet etching is the most effective and extensive method for achieving the expected structure, although dry etching and other special machining techniques have also been investigated. In this study, the dynamic wet etching process was recorded using different ratios of buffered oxide etcher (BOE) solutions as the etchant to reveal the etching mechanism. The experiments were first designed considering the fabrication of samples, experimental conditions, and measurement indicators. Subsequently, the corresponding etch rate, roughness, and surface morphology were investigated to control the process parameters during wet etching. Different etchants exhibit varying etching rates and roughness properties. A smaller proportion of hydrofluoric acid in the BOE solution results in lower etch rate, and vice versa. The roughness (Ra) in the stable stage was not completely consistent with the tendency of the etch rate, whereas the surface morphology and dimensions of the pyramids rationally complied with the roughness trend. Additionally, the results suggested that the three following stages exist during the wet etching process of the z-cut α-quartz wafer; smooth, incremental, and stable. The analysis of the dynamic wet etching process in this study is beneficial for the structural design, manufacturing, and performance of quartz MEMS devices.

Research on the Mesa Etch of OEIC

Research on Integrated Trench Etching for Trench-Type Power MOSFET

Research on K9 Glass Wet Etching for MOEMS Devices

A Study On Etching Profiles Of Sacrificial Layers

A Systematic Study on Dry Etching Process of Germanium for Ge 3D-Fets Applications

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

Dynamic Process of Wet Etching Using BOE Solutions to Control the Etch Rate, Roughness, and Surface Morphology of a Z-cut Α-Quartz Wafer

A Modified Bosch Process of SF6/C4F8/O2 ICP-RIE Si Etching

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

Investigation and Modeling of Etching Through Silicon Carbide Vias (TSiCV) for SiC Interposer and Deep SiC Etching for Harsh Environment MEMS by DoE

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

REACTION SIMULATION AND EXPERIMENT OF A Cl2/Ar INDUCTIVELY COUPLED PLASMA FOR ETCHING OF SILICON

Study on Silicon Deep Wet Etching Technology for MEMS

A Chemical Polish-etching of Optics Suface Based on the Marangoni Interface Effect

Etching Research of ITO Films in PDP

Research on Silicon Wafer Surface Phase under the Ultra-thin Slicing Process and Its Etching Hindrance Behavior during Metal-Assisted Chemical Etching

Fabrication of a sidewall reflective optical switch by using FIB etching

Development of Ge Isotropic Wet Etching Solution and its Application to High Quality Ge-on-Insulator Fabrication through the Etchback Method

Researches on selective electrochemical-etching for Cu/Ni sacrificial layers

Etching of Ga2O3: an important process for device manufacturing

Improvement on the Uniformity of Deep Reactive Ion Etch for Electrically Isolated Silicon-Based Substrates