Abstract:Defects may be induced by the degradation in long-term service of the equipment, where its components experience complicated conditions such as alternating loads, wearing or fretting conditions and creep. To repair the defects, cutting is the traditional approach to smooth the local profile, reduce the stress concentration and elongate the service life. This paper compared two plans to repair the shafting abrasion defects as the long-term wearing effect of foreign objects, observed in a 660. MW steam turbine. The first plan introduces relatively smaller cutting, compared with the second plan which takes a larger cutting volume with smoother profile. The analysis is following: (I) the local stress concentration at the abrasion location has been presented in contrast of the variation of the stress; (II) torsional vibration features are studied in detail with the shafting model, to determine the influence of the abrasion defects and to analyze the variation caused by the repairing cutting; the torsional vibration responses under four types of fault conditions are compared through the static, transient and steady responses; (III) local stress responses in weak locations of the shafting are acquired, and then the fatigue damage in these locations are further evaluated. The results indicate that, the second plan presents lower stress concentration, on the contrary, the first plan brings higher stress concentration, however it introduces less variation in the torsional vibration corresponding to smaller stress amplitude, and further causes less fatigue damage at the spot of fault. The first plan with relatively smaller cutting volume is therefore suggested as the primary repair plan. © 2012 Elsevier Ltd.

Torsional Vibration Analysis and Stress Calculation for the Fault 600MW Steam Turbine Generator Shaft System

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Torsional Vibration of a Shafting System under Electrical Disturbances

Shaft crack analysis and diagnosis for the 600mw steam turbine generator

Study on stress and strain for fatigue cumulation evaluation in turbine generator shafts due to torsional vibration

Fatigue Damage of Turbine Generator Shafting Caused by Subsynchronous Oscillations

Time-frequency Analysis on Torsional Vibration of Turbo-generator Shafts

Study On Torsional Vibration Of Turbine Generator Shafts Owing To Network Disturbance

Coupled Torsional Vibration and Fatigue Damage of Turbine Generator Due to Grid Disturbance

Signal Analysis on Flexural and Torsional Vibration of Generator Shafts Impacted by Subsynchronous Resonance

Fatigue Damage Evaluation Of Turbine Generator Due To Multi-Mode Subsynchronous Oscillation

STABILITY ANALYSIS OF THE SHAFT TORSIONAL OSCILLATION BASED ON LYAPUNOV DIRECT METHOD

Suppressing Axial Torsion Vibrations on Turbine Shafts by Solid State Fault Current Limiter

Crack Growth Prediction Of The Steam Turbine Generator Shaft

Dynamics of Slant Cracked Rotor for a Steam Turbine Generator System

Torsional vibration and fatigue evaluation in repairing the worn shafting of the steam turbine

Lyapunov stability analysis of turbine-generator including shaft system

Life Damage of Shaft and Spider in Hydraulic Generator Unit Based on Vibration Signal

Research of Unsteady Aerodynamic Force and Oscillating Flow Field Around Cascade on Shafting Torsional Vibration

Online analysis method for turbonator shafting fatigue damage caused by subsynchronous oscillation

Dynamic Analysis and Study on Shaft's Torsional Vibration of Electrical Traction Shearer's Motor-Rocker and Deceleration System