Abstract:Multi-loop theory is the most common and effective method used for analyzing stator winding internal faults of synchronous generators. Based on the current analysis methods, this paper modifies the existing models and introduces the motion equation of rotor into the Multi-loop analysis model to describe the associated relations between main parameters (e.g. current, voltage, torque, speed of rotation) of generator. Since the starting process of motor contains abundant information, this paper analyzes the influence of internal faults to relevant parameters, during the starting process from zero to rated speed. Through analysis some conclusions can be obtained as follow: when stator winding internal faults occur, since the influence of space harmonic is stronger, electromagnetic torque is on oscillatory regime. All waves are distorted when turn-to-turn faults occur. The starting current is bigger than normal, and the current will fluctuate after stabilization. The changing trends of short circular current and neutral-point current are the same. The currents are both small when starting, then gradually decay and go stabilization after an obvious increasing. The amplitudes of currents are far bigger than every branch current of stator. After faults, the electromagnetic torque of motor changes a lot and there is still an oscillation with certain amplitudes after stabilization. More short turns would cause bigger amplitudes of oscillation.

Suppressing Axial Torsion Vibrations on Turbine Shafts by Solid State Fault Current Limiter

Transient Analysis Of Synchronous Generator With Stator Winding Faults Based On Starting Process

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Torsional Vibration of a Shafting System under Electrical Disturbances

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

Impact of Solid State Fault Current Limiter on Double-source Systems

Time-frequency Analysis on Torsional Vibration of Turbo-generator Shafts

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

Study on Magnetic-Shield-type Air-Core Transformer Coupling SSFCL

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

Simulation Study of New Solid-State Fault Current Limiter

Control strategy of transformer coupling solid state fault current limiter and its experimental study with capacitance load

Torque Oscillation Suppression of DFIG-based Wind Turbines under Unbalanced and Distorted Grid Voltage Conditions

Coupled Torsional Vibration and Fatigue Damage of Turbine Generator Due to Grid Disturbance

Torsional Vibration Analysis and Stress Calculation for the Fault 600MW Steam Turbine Generator Shaft System

A Novel Six-Leg Three-Phase Fault Current Limiter

Effect of Electric System Disturbances on Torsional Vibration of Turbine Generator Shaft Systems and Active Control of Torsional Vibration

A DC Solid-State Transformer with DC Fault Ride-Through Capability

STUDY ON CONTROL SYSTEM OF THREE-PHASE SOLID STATE FAULT CURRENT LIMITER

Control Strategy and Test Study of Bi-directional Current's Solid State Fault Current Limiter

Fault-Tolerant Control of Dual-Three-Phase PMSM under Open-Phase Fault Based on Two-Individual Current Control