Abstract:When a pole-to-pole dc fault occurs in a multi-terminal HVDC system, it is desirable that the stations and dc solid-state transformers on healthy cables continue contributing to power transfer, rather than blocking. To reduce the fault current of a modular multilevel converter based dc solid-state transformer, active fault current control is proposed, where the dc and ac components of fault arm currents are regulated independently. By dynamically regulating the dc offset of the arm voltage rather than being set at half the rated dc voltage, the dc component in the fault current is reduced significantly. Additionally, reduced ac voltage operation of the dc solid-state transformer during the fault is proposed, where the ac voltage of transformer is actively limited in the controllable range of both converters in the transformer to effectively suppress the ac component of the fault current. The fault arm current peak and the energy absorbed by the surge arrester in the dc circuit breakers are reduced by 31.8% and 4.9% respectively, thereby lowering the capacities of switching devices and circuit breakers. Alternatively, with the same fault current level, the dc-link node inductance can be halved by using the proposed control, yielding lowered cost and volume. The novel active fault current control mechanism and the necessary control strategy are presented and simulation results confirm its feasibility.

A DC Solid-State Transformer with DC Fault Ride-Through Capability

Fault Tolerance Scheme for a DC Solid State Transformer

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

Active Control of DC Fault Currents in DC Solid-State Transformers During Ride-Through Operation of Multi-Terminal HVDC Systems

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

A Practical DC Fault Ride-Through Method for MMC Based MVDC Distribution Systems

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

Control of a Hybrid Modular Solid-State Transformer for Uninterrupted Power Supply under MVdc Short-Circuit Fault

Fault control and line protection strategy for LVDC microgrids based on modified high-frequency-link DC solid state transformer

A Hybrid Isolated Bidirectional DC/DC Solid-State Transformer for DC Distribution Network

Active Current-Limiting Control Based DC Fault Ride-Through of Full-Bridge MMC

Study on Magnetic-Shield-type Air-Core Transformer Coupling SSFCL

An improved topology of isolated MMC with fault ride-through capability under MVDC fault

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

DC Solid State Transformer Based on Multilevel DC Link for Medium-voltage DC Distribution Application

High-frequency-link DC Solid State Transformers for Flexible DC Distribution

Efficiency Enhancement of DC Solid-State Transformers by Dynamically Adjusting Active Cells

Fault Characteristics and Riding-Through Methods of Dual Active Bridge Converter Under Short-Circuit of the Load

DC Solid State Transformer Based on Three-Level Power Module for Interconnecting MV and LV DC Distribution Systems

The Redundancy Fault-Tolerant Control Strategies for Modular Solid State Transformer with DC Bus

Enhanced Fault-Tolerant Operation Strategy for Cascaded Vienna Front-End Based Solid-State Transformer