Abstract:During the operation of a steam turbine, its structural elements are subjected to significant thermal and mechanical loads. The consequence of the long-term effect of such a load is the accumulation of scattered fatigue damage to the material of the structural elements of the steam turbine, which is localized over time in the form of fatigue cracks of various types. Evidence of this is several accidents and catastrophic failures of steam turbines due to significant fatigue damage to the shafting. The localization of damage in turbine rotors is facilitated by stress concentration in the gouges and fillets, as well as damage to the surface layer of the rotors during the thermomechanical treatment stage since all metal processing operations (forging, turning and milling, heat treatment) are accompanied by plastic deformation of the material. One of the reasons for the long-term accumulation of fatigue damage in the structural elements of steam turbines is thermal stresses, which can reach dangerous values during turbine startup operations. In certain parts of the rotors, these stresses are sufficient to cause scattered fatigue damage to the material (the so-called thermoplasticity), especially when starting the turbine from a cold state. In the case of crack initiation, the thermal stresses are all the more sufficient for its further intensive development even when starting the turbine from uncooled and hot states, which are less damaging than starting from the cold state. To study the intensity of crack growth in the turbine rotor due to thermal stresses arising during turbine startup, a computational model based on using a finite element model of the shaft of the K-200-130 steam turbine and fracture mechanics approaches is proposed. Studies based on the proposed computational model have demonstrated the ability to predict the process of crack growth in the rotor due to turbine startup from different thermal states and assess its danger to structural integrity. The initial size of the internal annular crack was determined, which has the potential for further intensive growth under the influence of thermal stresses.

Crack Growth Prediction Of The Steam Turbine Generator Shaft

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Shaft crack analysis and diagnosis for the 600mw steam turbine generator

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

Study on stress and strain for fatigue cumulation evaluation in turbine generator shafts due to torsional vibration

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Estimation of Fatigue Crack Growth at Transverse Vibrations of a Steam Turbine Shaft

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

Coupled Torsional Vibration and Fatigue Damage of Turbine Generator Due to Grid Disturbance

Patterns of Transverse Crack Growth in a Steam Turbine Rotor Model Under Dynamic Loading

Torsional Vibration Analysis and Stress Calculation for the Fault 600MW Steam Turbine Generator Shaft System

Dynamics of Slant Cracked Rotor for a Steam Turbine Generator System

Crack Cause Analysis of Pulverizing Wheel in Fan Mill of 600MW Steam Turbine Unit

Patterns of Growth of an Internal Annular Crack Under the Influence of Thermal Stresses During Turbine Startup

Crack propagation life of high-speed aviation gear

Fatigue Failure Analysis of Shaft for NTK300 Wind Turbine

Study on the Effect of Cracks in Diaphragm Couplings on the Dynamic Characteristics of Shaft System

Nonlinear Dynamic Characteristics of Wind Turbine Gear System Caused by Tooth Crack Fault

Analysis of Crack Propagation in Onshore Wind Turbine Foundations Using the Double-K Fracture Model

Study On Torsional Vibration Of Turbine Generator Shafts Owing To Network Disturbance

The Effects Of Longitudinal And Circumferential Cracks On The Torsional Dynamic Response Of Shafts