Abstract:Bulb turbine units are widely used in run-of river or dam projects with relatively low head, and can also be used for tidal energy utilization. Some types of bulb turbines have excessive vibration and fatigue failure problems, which threats their fatigue life. The model analyzed in this paper is a prototype bulb turbine rotor which suffered cracks, probably due to erosion and welding defects. The dynamic stress characteristics are analyzed under not only the non-cracked shaft condition but also the cracked one, to find possible causes of the failure. The computational fluid dynamics (CFD) simulation is performed to obtain reliable hydraulic load on the runner for performing the FEM analysis. The CFD results are verified by comparing with the site test for the prototype one. The linear elastic fracture mechanics theory combined with the fluid-structural interaction theory is applied to developing a cracked FEM model, to obtain the dynamic stress characteristics for the runner, shaft and rotor. The results reveal that the change in dynamic stress level on the shaft flange root significantly depends on the operating conditions, and the stress amplitude on the shaft mainly depends on the structural weight. The stress at the cracked zone could be up to 376.5 MPa in the best efficiency point, with only 1.5 years of fatigue life. Based on the numerical calculations and site inspection, it could be concluded that the insufficient sealing could lead to leakage flows with specific flow rates in flange root, which resulted in the occurrence of erosion; in addition, the welding at the flange root probably generated tiny defects. These two factors are likely lead to fatigue cracks and major failure of the shaft. Suggestions for solutions for the problems of the shaft are also discussed. Results of this study helps to find the reasons of the shaft fatigue failure. Furthermore, the analysis method could be used for an accurate calculation of fatigue life and providing guidance in future designs and operations of bulb turbine units.

Study on stress and strain for fatigue cumulation evaluation in turbine generator shafts due to torsional vibration

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Coupled Torsional Vibration and Fatigue Damage of Turbine Generator Due to Grid Disturbance

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

Torsional Vibration Analysis and Stress Calculation for the Fault 600MW Steam Turbine Generator Shaft System

Crack Growth Prediction Of The Steam Turbine Generator Shaft

Shaft crack analysis and diagnosis for the 600mw steam turbine generator

Estimation of Fatigue Crack Growth at Transverse Vibrations of a Steam Turbine Shaft

Fatigue analysis in rotor of a prototype bulb turbine based on fluid-structure interaction

Dynamics of Slant Cracked Rotor for a Steam Turbine Generator System

Stress of Francis Turbine Runners under Fluctuant Work Conditions

Torsional vibration and fatigue evaluation in repairing the worn shafting of the steam turbine

Fatigue Failure Analysis of Shaft for NTK300 Wind Turbine

Fatigue Damage of Turbine Generator Shafting Caused by Subsynchronous Oscillations

Fatigue Damage Evaluation Of Turbine Generator Due To Multi-Mode Subsynchronous Oscillation

Fatigue Failure Analysis of Shaft in As-developed Wind Turbine with Reinforced-welding Elbow

Multi-axial Creep-Fatigue Analysis of a Cracked Groove Structure Subjected to Cyclic Thermal Loading

The Strength Design and Check of Turbine Generator Based on FEA and Fatigue Evaluation

Fretting fatigue crack analysis of the turbine blade from nuclear power plant